Jump to content

OL-fault ..help


jas98

Recommended Posts

  • Member
  • Member For: 12y 5m 2d
  • Gender: Male
  • Location: Maryborough Qld

Hi all. Trying to find cause. Ba xr6t.

 

Few week back car just started have random miss at idle or taking off. Took home had codes for TPS and throttle pedal sensor. Oxygen sensor. . So swapped TPS and O2 sensor and was all good for a little bit. .

 

Last week noticed that car had slight miss at idle again. And was idleing higher (slightly .like 50rpm ) so hooked forscan up and had 3 codes for oxygen sensor. So though we'll the one I swapped with maybe it was I <3 Bananased. So bought new Bosch one. Came good perfect. Drove it couple days but I <3 Bananas then  noticed it was drinking fuel ..

 

Today for 1/4 tank it only done 62ks.....can smell it running Rich and has a oxygen sensor code lean. ...no other codes 

 

But when was on forscan noticed O2 sensor was at .85 volts and steady and also it's stuck in OL-fault. It did switch to open loop for about 20 min while driveing and ran smoothly but then while cruising home at 60 kph it droped back to OP-fault.  Seems to be stuck in this OL-fault mode hence why it's drinking fuel

 

 

Now over last few months I've replaced every sensor and injectors etc as I wanted to change Al those but I'm not ruling any sensors etc out. They were not eBay junk either though. 

 

I've read a bit and seems it could be the coolant/head temp sensor? Or fuel pressure/injector. I've checked the fuel reg (it's also only few weeks old) and fuel pump is about 6 months old no vacume leaks 

 

I did do a Kam reset through forscan which I've done before without issues so hopefully that hasn't caused any issues as I did this after I did the TPS sensor 

 

Any suggestions would be great. It's gone from useing about 14. Lph round town to now 24 lph round town and climbing 

Link to comment
Share on other sites

  • Member
  • Member For: 12y 5m 2d
  • Gender: Male
  • Location: Maryborough Qld

So have had allok. Can find any broken wires or leaks ...fuel reg checks out ok. Have thought and seeing the O2 sensor code it has now it a lean code and system defaults to OL-fald and not closed loop etc. Maybe injector stuffed so computer is just pumping fuel in so it doesn't lean out? Or even fuel pump weak?

 

I know in therory it shouldn't as yeah no fuel through would mean your saving fuel but if computer sees it lean it will hold the injectors open more/longer??

 

Otherwise if it had a air leak it would idle hell high but it's not and can find any leaks while running

Link to comment
Share on other sites

  • Puff
  • Gold Donating Members
  • Member For: 9y 10m 25d
  • Gender: Male
  • Location: South Australia

A small air leak wont make it idle high. The car uses timing to change the engine idle speed so a vacuum leak will result in very low idle timing. Air leaks will hide in hoses in the form of cracks and it is fairly common to see them between the manifold and head and in the manifold halves.

 

There could be a blocked injector, you can remove them and swap the filter baskets pretty easily. If you think it might be the CHT then check the output of the sensor with a scanner.

Link to comment
Share on other sites

  • Member
  • Member For: 12y 5m 2d
  • Gender: Male
  • Location: Maryborough Qld

Thanks all. Swapped injectors and reset battery ...thought I was onto something as it idles fine...O2 sensor was fine and reading as it should ...so let it idle for 5-10 min and as I was walking back (when it was warm) I herd it missfire and revs dropped like a mover starving for fuel and it shot revs back up to like 2500 RMP for a couple seconds and slowly idled back down...at this point is idled rough splutted and then started idleing again..although little miss .

 

When this was happening the O2 sensor reading was spazzing out like it was loosing power ...gaining power instantly etc. ..

  

After inlet it idle while it was little rough and wiggled all wireing I could see/get to without burning myself etc and nothing changed 

 

Turned it off and yanked the battery cables a little and started it and it seemed fine again.......prob a coincidence as it does come good sometimes 

 

Question can a bad engine earth strap cause this...like can it cause stupidly high fuel usage??? And these symptoms. 

One other thing I noticed was the air con jist randomly tirned off as pulling into driveway when I hit a bump aswell which it never has done that and it also did it in the driveway while this was all happening aswell

Link to comment
Share on other sites

  • Member
  • Member For: 12y 5m 2d
  • Gender: Male
  • Location: Maryborough Qld

Also just rescanned for codes and none in pcm but did have a low battery code in bem battery is fine though and yes tested etc it's fine 

Link to comment
Share on other sites

  • 1 year later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'