Jump to content

my 03 xr6t splutters between 3 and 4 k


bee30dee

Recommended Posts

  • New Member
  • Member For: 4y 10m 10d

hi

I'm having a problem with my 240kw Barra

she drives good and changes gears normal up to 3 to 4k runs 6psi 

has no folt codes 

then when it  hits 3 to 4k revs the motor splutters and the 6 psi turns to 12 psi well the gauge goes up to 12

then the motor runs rough and and smells lean I don't get an engine light come on then I turn it off and restart it and it runs normal

I've replaced the plugs twice the coils 2 tps sensor turbo solenoid 

if you could help would be great thank you in advance

Edited by bee30dee
Link to comment
Share on other sites

  • Replies 20
  • Created
  • Last Reply

Top Posters In This Topic

  • less WHY; more WOT
  • Site Developer
  • Member For: 16y 9m 20d
  • Gender: Male
  • Location: Melbourne

could be a collapsed cat... e.g. with a small amount of flow (lower revs) it doesn't obstruct the flow but once it gets into higher revs with the same boost level there's more air flowing through per second and it gets blocked a bit so the turbo gets more backpressure and spikes the boost up higher than it should... only a guess, though. Best to take it to a dyno/mechanic and run it up to see what it's doing.

Link to comment
Share on other sites

  • less WHY; more WOT
  • Site Developer
  • Member For: 16y 9m 20d
  • Gender: Male
  • Location: Melbourne

The stock exhaust is 2 1/4 inch twin after the cat. If it's aftermarket, it could just be cat-back, but if it's dump or cat + cat-back, it can cause issues with a stock tune.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.



×
  • Create New...
'