Jump to content

BA XR6T Rough Idle, no throttle when cold.


Recommended Posts

  • Member
  • Member For: 5y 10m 19d

Hi everyone.

 

I've recently developed a problem with my BA XR6 Turbo that's got me bested.

When its cold, I cant throttle without the car leaning out and nearly conking out / poping in the intake. Being persitant with the throttle makes the problem pass and goes on to disappear completely when the engine warms up over a quarter gauge.

What I've replaced:

 

Brand new Genuine Bosch O2 sensor.

Brand new Genuine Bosch Fuel Pressure Reg.

Cleaned Factory Injectors.

Brand new Ryco Fuel Filter.

Brand new Walbro 255LPH Pump.

 

These were done prior to issue arrising and car was driven faultlessly for about 1500Kms.

 

Since developing the issue I've done:

 

Brand new Genuine Spark Plugs.

 

I've scanned the car, it's not throwing any codes.

 

My current fix has just been idling the car till warm and then going on with my travel.

 

Cheers in advance.

Link to comment
Share on other sites

  • Bronze Donating Members
  • Member For: 13y 4m 20d

I would say 99% this is not your issue, but it's an easy one to prove.

The ecu's in ba's are prone to failure when cold or hot. Usually doesn't cause this issue but still. Pour a kettle of hot water over the ecu before driving.


Other issue you may have a vacuum leak.

Link to comment
Share on other sites

  • less WHY; more WOT
  • Site Developer
  • Member For: 16y 8m 1d
  • Gender: Male
  • Location: Melbourne

so you're waiting for the car to get warm with regard to coolant to get proper boost/power in the top end... sounds like coils to me, but could be a bunch of things...

Link to comment
Share on other sites

  • 7 months later...
  • New Member
  • Member For: 3y 11m 23d
On 11/05/2020 at 10:24 AM, gaz097 said:

I would say 99% this is not your issue, but it's an easy one to prove.

The ecu's in ba's are prone to failure when cold or hot. Usually doesn't cause this issue but still. Pour a kettle of hot water over the ecu before driving.


Other issue you may have a vacuum leak.

what does the hot water do and if it’s stops the rough idling then how and what’s causing it 

 

I’ve changed coils,plugs,02sensor,I had only put on new keyless pads with keys and did it fords way press rear demister button for three times and when door locks open press each button on each pad so you know they are setup correctly 

First drive after doing these my car has been idling fine when cold as soon as it’s upto normal driving temperature the car idles very roughly when I put it into neutral it’s okay 

WHAT IS CAUSING THIS NIGHTMARE OF AN ISSUE SURELY MY CAMSHAFT HASNT GOT THIS LUMPY GRIND IT WOULD HAVE DONE IT PRIOR TO THIS IVE HAD CAR SEVEN YEARS NOW ONLY 112,300klms very good condition

  • Like 1
Link to comment
Share on other sites

  • 3 years later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'