Jump to content

Fg turbo ute rear knocking


Lithfkn

Recommended Posts

  • Bronze Donating Members
  • Member For: 8y 4m 5d

^ this

 

Sure it’s not diff related? Have you checked from the box back as far as driveline bushes, centre bearing and what not? 

 

I had had a similar knock in my sedan and it turned out to be movement in the driveline due to engine/gear box mounts etc. 

 

Just a thought

Link to comment
Share on other sites

  • Member
  • Member For: 5y 5m

It was at a driveline joint getting looked at. They couldnt recreate the sound without driving it. They did mention the cvs were fine and the centre bearing was slightly sagging and had a tiny tear at the top but wouldn't bother replacing until you could feel it going. There's no vibration at speed.

 

What kind of bushing do the 6 spd manual boxes run? Where do you even get them from? 

 

Cheers

Link to comment
Share on other sites

  • Silver Donating Members
  • Member For: 10y 10m 8d
  • Gender: Male
  • Location: SW Sydney
  • Member
  • Member For: 5y 5m
  • Bronze Donating Members
  • Member For: 8y 4m 5d

By all means if you’re in there doing it, why not go a little further. It can’t hurt that is for sure. 

 

My car was 1000 times better when I did all mine. Fixed all my apparent suspension issues that were similar to yours. I did do engine mounts to at the same time however just because (1 was on the way out) 

Link to comment
Share on other sites

  • Member
  • Member For: 5y 5m

I'll definitely check it out. Easy enough to do at home on the garage floor? Mark the tailshaft, bolts in / bolts out sort of arrangement? Hard to get a part number for a centre bearing as I've been reading theres some variety with these things!

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'