help need valve springs replaced ba xr6 turbo in adelaide

[Puffwagon]

I'll pm ya some stuff so we don't derail the thread too much.

[arronm]

6 hours ago, adams355 said:

Yea I did look, some other threads were saying 3/8 just wanted to get it right before start buying and welding. Thanks Puff. 

You talking about this or this . See below. For the boost sensor the bolt is 6mm and the hole is 11.8mm Process west can send you an adapter for the boost sensor.

 

 

Boost sender is 1/8 BSP (Taper)

 

Both parts in the below image. 6S701 and 6S775

 

 

 

My setup when I had process west. Kev sent me this, boost sender adapter

 

Edited 06/08/18 05:20 PM by arronm

[arronm]

Regarding OP valve springs. If in Adelaide just get Jet to buy and install them Job done...

 

 

Look at the time, I stayed up so late now its my birthday.

Edited 06/08/18 05:23 PM by arronm

[adams355]

Yep, thanks arronm its for the MAP sensor 6S701 the one on the metal pipe under the battery (first picture)

 

Re valve springs is just an option for the budget minded, I put it here because its a new thread.