Jump to content

Leak help!


LazyBrennan

Recommended Posts

  • Donating Members
  • Member For: 13y 8m 27d
  • Gender: Male
  • Location: Baldivis, Wait Ages.

Ok guys I am all out of ideas what to check. 

 

I am loosing a lot of boost. Should be getting 22 psi and only getting 11 psi. The car idles like an absolute pig and stalls. Little issues are noticed like cruise control for example, I cant actually increase speed. 

All things point towards a leak somewhere.  

 

We have done a compression test and leak down test on the motor and results were all good, We made a device to hook up to the intake and pumped about 30 psi through the whole system trying to hear for a leak and nothing. PCV was checked, Intake manifold gasket was all good (still fairly new and we did pull it apart to check) The actuator has been checked, Throttle body is clean and gasket fine too. Gaskets have been replaced on the turbo. I have tried using a flammable spray like brake cleaner ect around fittings to listen for a change in idle revs and nothing. 

Also getting the P1131 error engine light code. This engine light comes on at just normal driving speeds. I am sure there is things we have checked and I've for gotten to mention. 

I am completely stumped as to what else it could be. 

 

Any ideas of things to have a look at would be a massive help. 

Link to comment
Share on other sites

  • Donating Members
  • Member For: 13y 8m 27d
  • Gender: Male
  • Location: Baldivis, Wait Ages.

Cats been gutted.

 

15 minutes ago, k31th said:

coils?

maybe a coil driver from the PCM?

Would I still be able to get desired fuel though if that was the case? Was roll racing the other night only getting about 11-12 pounds of boost but my lambda gauge was showing a nice 0.82 the whole time.

Link to comment
Share on other sites

  • less WHY; more WOT
  • Site Developer
  • Member For: 16y 8m 9d
  • Gender: Male
  • Location: Melbourne

so it actually goes alright when you're up it? e.g only idles and cruises badly? I wouldn't trust an AFR gauge unless you've installed a separate wideband, which I assume you've done, so that doesn't matter anyway.

Link to comment
Share on other sites

  • Donating Members
  • Member For: 13y 8m 27d
  • Gender: Male
  • Location: Baldivis, Wait Ages.

Well it goes alright for 11 pounds of boost but it should be getting 22. 

The AFR gauge is a PLX one with a separate 02 sensor installed for it. Its about 2 months old. 

Link to comment
Share on other sites

  • Donating Members
  • Member For: 13y 8m 27d
  • Gender: Male
  • Location: Baldivis, Wait Ages.

Yup 

 

3 minutes ago, k31th said:

I'd still be checking the coils and wiring to the coils as a first step from here...

Ill have a look

Link to comment
Share on other sites

  • Dropping a turd
  • Gold Donating Members
  • Member For: 17y 1m 22d
  • Gender: Male
  • Location: Perth

Have you checked the turbo.  Sounds like your not leaking boost, the car just isn't making 22psi.  What does your tuner think.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'