ZF conversion into older car, is it possible?

[sprouly07]

Hey guys, so as the title says im just wondering if anyone knows if it is possible to swap a zf auto into a car that is say 30 years old and get it to actually run. I'm more worried about getting the zf to work than the motor because I know we can get the motor to run. Is there a way to get the standard computer to run the zf and the motor in a completely different car or does the computer not like playing the game? If not the standard computer, is there something aftermarket that would allow the zf and barra to run happily.

[Puffwagon]

http://www.rrs-online.com.au/typhoon-turbo-conversions.html

[JETURBO]

Nothing is impossible....

 

lots and lots needs to be pulled from a zf donor vehicle and shoehorned into the classic vehicle 

 

nothing aftermarket can control the ZF 

[Puffwagon]

http://www.usshift.com/usq6.shtml

 

This can control the 6r80. It might not be too hard to adapt it.

[Ralph Wiggum]

It won't unfortunately. Although mechanically similar the brain in the 6r80 is quite different. It would be far more cost effective to use a factory setup modified to suit.

 

  On 12/10/2017 at 12:56 AM, JETURBO said:

Nothing is impossible....

 

lots and lots needs to be pulled from a zf donor vehicle and shoehorned into the classic vehicle 

 

nothing aftermarket can control the ZF 

Expand  

It can be done with just the PCM and wiring for the trans. transplanting into an older chassis that doesn't require BEM or ABS integration is a much easier task.

 

 

OP it's entirely possible, as always best to start with a donor vehicle and make sure whoever you use understands the conversion otherwise the cost will rack up very very quickly.

[Puffwagon]

  On 12/10/2017 at 1:16 AM, Ralph Wiggum said:

It would be far more cost effective to use a factory setup modified to suit.

Expand  

 

I think that if using a zf is mandatory then this bit of info is the take home here.

[Ralph Wiggum]

  On 12/10/2017 at 1:02 AM, Puffwagon said:

http://www.usshift.com/usq6.shtml

 

This can control the 6r80. It might not be too hard to adapt it.

Expand  

Looking at this in detail it looks like a nice piece of kit, however someone would need to be willing to strip the TCM from a 6hp26 and rewire to run off the standalone controller (the unit is designed to run a 2011+ 6r80 which doesn't have an integral TCM) but the major flaw I see for us is all the mapping is TPS based load not MAP based. As we know with a turbo car under 100% TPS, TPS and Load don't always correlate.

Edited 12/10/17 01:56 AM by Ralph Wiggum

[Puffwagon]

Even that issue aside it wouldn't be a cheap exercise running a standalone trans controller alongside a Haltech or similar ecu. Even if one was to wire/install/tune it themselves there would be stuff all change from $4000 if any.

This is the same place as the first link I posted.

[fnqfisher71]

Have one in my XP coupe behind a BF f6 typhoon engine

[Box stock T.]

Hey far north Queensland fisher, some pics of the engine bay would back up your wild claims. Hahaha.

Only joking mate.

 

Pretty sweet piece of classic steel married to a trick modern engine/ trans combo.

Welcome to the forum as well champ.

Go The Storm. Hehe.