Where do I run my boost guage too?

[BarraLoke]

Hey there just woundering if someone could post a few photos of where they T'd into the vac lines to get a reading on boost guage? All photoa in old threads about the issue are no longer availavle

[k31th]

find the BOV (behind the crossover pipe on a B-series), take the vac line from the top of the BOV and cut it, put a t-piece into the location and run your vac line from there to your gauge.

[MBAF]

^ that or anywhere on the inlet manifold side is fine

[BarraLoke]

Cheers k13th but photos would be a massive help

[k31th]

I don't have a pic as my current car doesn't have a boost gauge and I don't have a pic from my previous car that had a boost gauge

 

Edit: it's the skinny line coming out of the top of the BOV like this ->

Edited 03/04/17 07:09 AM by k31th

[BarraLoke]

A photo of the line you would cut if you were to install one? 

[k31th]

I've taken the BOV off my car completely and stoppered it, so it's not quite so simple haha hopefully the pic from the workshop manual above is enough for ya it's pretty straightforward.

[espoig]

[BarraLoke]

 

 

Mine must of been removed too? 

[arronm]

Run it off the brass T  at the rear of the inlet manifold.