Jump to content

Fg Offsets And Tyre Questions


Dillz

Recommended Posts

Guest XR09
  • Guests

Yes Corzza they will fit nice. Fronts will look in a bit. I have 245 x 35 offset on the front of mine.

I have 275's on the rear with a 42 offset and they sit nice and flush. so I am thinking a 295..10" with the 32 should be good.

Big question is are you going to do the brakes?

The std look shoite. Specially if you have a mag that exposes them.

Your fronts will be ok. Not sure about the rear 32 going over a 4 pot rear Brembo, it would have to be bloody close to going on

Link to comment
Share on other sites

  • Three pedals are better then two..
  • Donating Members
  • Member For: 17y 5m 10d
  • Gender: Male
  • Location: Melbourne

I'm sure a 32 will smash the guard if lowered, 40 sits just inside. If my rears went another 8mm out I'd be in trouble.

Link to comment
Share on other sites

Guest XR09
  • Guests

I'm still thinking yours will be fine @32. Very flush lol.

On a serious note it does have to fit or get the guards pumped. No lip to roll there.

Mine are in the guard, well for most of the upper half of the wheel with a 42 offset.

post-33767-0-88989800-1321422153_thumb.j

Link to comment
Share on other sites

  • Three pedals are better then two..
  • Donating Members
  • Member For: 17y 5m 10d
  • Gender: Male
  • Location: Melbourne

You don't really want flush you want in the guard. Flush will just ruin you tyres and wheel arches.

Anyone know roughly what pumping the guards is worth?

Link to comment
Share on other sites

Guest XR09
  • Guests

I think and CNBF googlingaling. Usually the lower the number in a positive offset the deeper the dish. The more they stick out the guards.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'