Kato1290 Member 35 Member For: 7y 10m 25d Posted 06/03/17 10:09 PM Author Share Posted 06/03/17 10:09 PM No change with that one :-( Link to comment Share on other sites More sharing options...
JETURBO ...JD TUNING ADELAIDE... Gold Donating Members 23,708 Member For: 16y 7m 10d Gender: Male Location: Adelaide Posted 06/03/17 10:21 PM Share Posted 06/03/17 10:21 PM That's because a rated actuator is the point where it will start to bleed off not the total amount of boost it will run an incorrectly set 12psi actuator can record over 20lb of boost with no lines connected ....your 5psi one could be easily smacking 10psi and stock injectors are all kinds of out by 10psi in the deep end you're asking for a rod out the side of the block you need a tune buddy, bite the bullet ! 1 Link to comment Share on other sites More sharing options...
Puffwagon Trust me bro... Gold Donating Members 16,045 Member For: 9y 11m 12d Gender: Male Location: South Australia Posted 06/03/17 10:51 PM Share Posted 06/03/17 10:51 PM Hopefully it wasn't run with no line! Obviously it was always going to run less boost with a line between the comp housing and actuator but it clearly wasn't enough. There's a few more factors at play as well such as wg flow, preload as mentioned and exhaust restriction. A big compressor isn't suited for the smaller wg holes and will struggle to run low boost up top. Just for sh*ts and giggles I drove my car on the 11.8 psi gate and it held 10 psi until about 4k then crept up to 15 or 16 up top. Anyways it was worth a shot I suppose. A couple of psi extra won't hurt but you can't have it leaning out due to injector dc. Unfortunately it is tune time or stock turbo time. Link to comment Share on other sites More sharing options...
Kato1290 Member 35 Member For: 7y 10m 25d Posted 07/03/17 08:26 AM Author Share Posted 07/03/17 08:26 AM Think ill look for stock turbo, that one is only oil cooled too and it gets fnk hot real quick, sh*t setup So ill need turbo and water lines, think its gunna be the best way PITA Link to comment Share on other sites More sharing options...
Kato1290 Member 35 Member For: 7y 10m 25d Posted 09/03/17 01:54 AM Author Share Posted 09/03/17 01:54 AM Hey boys can anyone confirm this is the stock turbo that I need? Link to comment Share on other sites More sharing options...
k31th less WHY; more WOT Site Developer 29,127 Member For: 16y 9m Gender: Male Location: Melbourne Posted 09/03/17 01:56 AM Share Posted 09/03/17 01:56 AM uhh, even if that is the right turbo, you can clearly see that it has bent fins, so it's not worth purchasing as you'll have to repair it at significant cost. 1 Link to comment Share on other sites More sharing options...
Kato1290 Member 35 Member For: 7y 10m 25d Posted 09/03/17 01:58 AM Author Share Posted 09/03/17 01:58 AM That was my next question haha I <3 Bananas I'm so over this sh*t Link to comment Share on other sites More sharing options...
discostig Manual mode ________________________ All day, erryday Donating Members 13,798 Member For: 17y 1m 16d Gender: Male Location: Probably above atmospheric pressure Posted 09/03/17 05:38 AM Share Posted 09/03/17 05:38 AM If it's got tits or wheels, it's gonna cost you money and cause you problems 1 Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now