Process West Piping Fit

[brendo169]

Hi guys,

Ive recently fitted a process west stage 1 intercooler and piping to my G6E. Had to shave about 3mm off the centre bar to clear the intercooler end tanks. Extremely satisfied with the quality of the kit but no matter how much fiddling with angles and what not had to do some trimming to the lower part of the front bumper to clear the pipes as they leave the intercooler. Has anyone ever had any isses with the siicone bends contacting the outer edge of the bumper support panel? My hot side piping is touching and im concerned that it may rub through in time. Does this happen? Or is it fine to leave it resting up against the spot weld lip. I've attached a photo of where im talking about. Thanks