Process West Stage 1 Vs Plazmaman Stage 1

[vanq69er]

Hi guys,

I am tossing up between the Process West Stage 1 vs Plazmaman Stage 1, obviously the big difference is that the Plazmaman requires some plastic trimming (radiator front support I think).

Is trimming the plastic a RWC issue? I am in Victoria and they are pretty strict. Does anyone have any pictures of the trimming required?

Also is there a big difference in performance between the two, I have heard the stepped part is a bit of a waste of time? I am planning for about 340rwkw.

Thanks all

[PTR_NITRO_FG]

Go the PW stage 1 (RWC = no cutting allowed).

PW1 good for 400rwkw apparently and tuner said its on par with a Plaz Stage 2

Stepped bit issue was more to do with early PWR kits I think?

/end thread

[vanq69er]

Awesome, thanks brother!

[PTR_NITRO_FG]

[ratter]

the front bar that has to be cut off is a structural part of the radiator support panel and is part of a legit rwc in Vic

[vanq69er]

Yeah no worries, forget that then. PW it is.

Also just checking, the Herrod CAI is road worthy right? Being a covered pod.

[Wilko16]

Technically your only allowed one intake modification in Victoria also...

So installing a cooler is legal, but throw an intake on as well and it's not, but yes the herrod CAI is legal

And you'd be hard done by getting in trouble for having both

[MickyB]

A very stupid question, but will the Process West Stage 1 kit bolt up fine to an FG MkII XR6T just fine? I am assuming that the kit suits both FG and FG MkII?

[huggy_b]

Yes

[MickyB]

Cheers