Jump to content

Recommend A Panel & Paint In Perth


Recommended Posts

  • Donating Members
  • Member For: 15y 11m 24d
  • Gender: Male

New door skin or pull the ding out of the existing skin? Make SURE that the inside of the skin is properly rust proofed after the work. Years ago, I pulled the door trim off a Datto Turbo only to find the panel beater had left it BURNED BARE METAL. Glad I checked. I slapped some rust proofer on pronto. I guess the dodgy repairers don't expect customers to look at their work inside the door??

PAH

Link to comment
Share on other sites

  • 2 weeks later...
  • Manual mode ________________________ All day, erryday
  • Donating Members
  • Member For: 17y 1m 18d
  • Gender: Male
  • Location: Probably above atmospheric pressure

Luke should post up his recommendations for Perth panel shops.

While we're at it, when I had my prang back in 2008, my car handed back to me with dirt and run marks in the rear bar clear coat prompt me not to recommend LJ Sciascia P&P. Was a while ago so I've gotten over it as I slowly collected more little dents and chips all over the poor girl :)

Link to comment
Share on other sites

  • 2 weeks later...
  • All stock bar the k&n panel filter
  • Silver Donating Members
  • Member For: 12y 9m 29d
  • Gender: Male
  • Location: Perth

Dropped the car in this morning and will pick it up Saturday, so I will post some after pics up then.

How'd you get on with this mate?

Link to comment
Share on other sites

  • Member
  • Member For: 15y 2m 27d
  • Gender: Male
  • Location: West Perth.

Well after a week in hospital with a respiratory tract infection and then being sent offsite for work, I will have some photo's up tonight - we block access to Imgur etc. at work, so I cannot login to upload the photos - I must admit Neil from Straight Line 2 Ten does awesome work, especially for the price.

  • Like 1
Link to comment
Share on other sites

  • Manual mode ________________________ All day, erryday
  • Donating Members
  • Member For: 17y 1m 18d
  • Gender: Male
  • Location: Probably above atmospheric pressure

Notice a big difference in person even on silver? Looks good, I probably notice it the most seeing reflections on the front bumper in the corner of the first pic .

Link to comment
Share on other sites

  • Member
  • Member For: 15y 2m 27d
  • Gender: Male
  • Location: West Perth.

Notice a big difference in person even on silver? Looks good, I probably notice it the most seeing reflections on the front bumper in the corner of the first pic .

No-one has noticed anything yet, one guy tried the old magnet to the door trick at work, after I told him to put some paper between it or I would thump him if he scratched the door again.

  • Like 2
Link to comment
Share on other sites

  • Member
  • Member For: 15y 2m 27d
  • Gender: Male
  • Location: West Perth.

Sounds like the cars going in for an early service now, it's due for one in October anyway but today it started idling roughly when stopped and I'm getting noises from the exhaust like small misfires, roughly 1 every 3 seconds. Here's some audio taken with the mobile phone http://youtu.be/mF7dHV83LiM

I am always careful with warming the car up, always sit there for 5 minutes until the needle rises above the second bar before even putting it into gear.

I'm using Nulon 10W40 oil, the only issue I've been told it has is the drive belt needs changing, which I was going to get done in a few weeks along with an oil change on the diff.

It's only done just over 83,000KM's. Also sometimes the idling makes the car shudder slightly. Oil has only done 3,000KM's, I would be lucky to do 5,000KM's between 6 monthly services.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'