Need Torque Specs For Fg

[Wilko16]

Thanks Phil

While on torque settings, pls can someone tell me the wheel nut setting

Thanks

125nm I do mine up to as well

Criss cross pattern also

Edited 10/05/15 05:39 AM by Wilko16

[hrick]

very helpful as always...Cheers

[QIKXR6]

FG Series

wheel nuts are torqued to 135 NM

(This spec is with a dry clean thread and taper)

Intake manifold - Cylinder Head: 17 -24 NM (FGT & N/A)

(N/A supports)

Intake manifold bracket (upper): 8-12 NM (manifold and cylinder head sides)

Intake manifold strut (lower): 17-24 NM (manifold and block sides)

Fuel rail to manifold 8-12 NM

[PTR_NITRO_FG]

^^^ Do you work for Ford? If not where did you get your manual?

[QIKXR6]

I don't have the manuals, was fortunate enough to get some of the factory fg torque specs for an engine rebuild a while back. Just trying to help out, I know how hard it is to get the correct specs for fg series.

[Mainline]

trying to find the correct torque setting for the collar nut on the output flange on my 2011 6hp26 zf auto, ford seem to think its a big secret