Jump to content

Am I Gunna Get There


Recommended Posts

  • Member
  • Member For: 10y 9m 20d
  • Gender: Male
  • Location: near brisbane

I know that they are hard to get of the line at the drags ,but I would like a manual for on the road .it is just more fun might be slower taking of but faster cornering and better control

  • Like 1
Link to comment
Share on other sites

  • 1 month later...
  • Member
  • Member For: 10y 9m 20d
  • Gender: Male
  • Location: near brisbane

engine is out today .going to pull it apart tomorrow so that on Saturday the engine builder can make up his mind which engine he will use (BA or the FG ) have the serge tank sitting at home plus lots of other parts like xforce 4 inch dump and 5 inch 100 cell cat . etc will not bore you any more with my comments . will let you know more soon .sorry still unable to post pictures .but there are pictures on the falcon club face book page as I can up load them there .sorry again just got no idea why it will not work ?

  • Like 1
Link to comment
Share on other sites

  • Member
  • Member For: 18y 5m 23d
  • Gender: Male
  • Location: Central Queensland

Glad to see that the build is still progressing. Just remember to be patient, as it always takes longer than expected (or planned) to get things done, and that quality work takes time.

Keep us posted on your progress. :D

  • Like 1
Link to comment
Share on other sites

  • Member
  • Member For: 10y 9m 20d
  • Gender: Male
  • Location: near brisbane

k31th ,something on my computer is stoping me from posting them . got no idea .I was lucky the car never went up in flames ,as the s.steel gasket let go at the dump pipe .it started to melt right down to bare wire the starter cable that runs on that side . it also blackened the paint on that side of the inner guard .it was not noticeable until I removed the heat shield .

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'