Jump to content

Gearbox/tailshaft Knock At <10Kms With > 30% Throttle.


rollex

Recommended Posts

  • Member
  • Member For: 10y 5m 22d
  • Gender: Male
  • Location: Australia

I do know my engine mounts are pretty average as the whole car rocks when I rev the engine and the bonnet shakes when I start it, however this all happened before the knocking noise. Is having shagged engine mounts likely to cause any issues other than increased NVH?

I'll get the centre bearing done with the diff bushes next week, if it is something else I'll get them to do that as well. Car has 190,000 on it so not surprised, pretty much every other bush and bearing has been replaced on it already.

Edited by rollex
Link to comment
Share on other sites

  • Replies 29
  • Created
  • Last Reply

Top Posters In This Topic

  • Member
  • Member For: 10y 5m 22d
  • Gender: Male
  • Location: Australia

Went to get it and the diff bushes replaced, they said the centre bearing was fine and the diff bush was completely f*cked and that was the cause. Drive the car home and find it still makes the noise just not as bad. The rear end is definitely better now but annoyed I have to take it back again.

FFS

Edited by rollex
Link to comment
Share on other sites

  • ...JD TUNING ADELAIDE...
  • Gold Donating Members
  • Member For: 16y 5m 30d
  • Gender: Male
  • Location: Adelaide

that's because numpkins "think" it looks ok but its not

Visual inspection can catch out some people

Push up on the tailshaft by the CB and it should only flex the rubber coupling a tiny bit, if u get +10mm on it shes no good and that's what thumps under load but only at certin speeds

Link to comment
Share on other sites

  • Member
  • Member For: 10y 5m 22d
  • Gender: Male
  • Location: Australia

Yeah its really mild now because the diff doesn't move any more but it is still knackered. I'll take it to a local mechanic, sick of driving that far.

Cheers

Link to comment
Share on other sites

  • 2 months later...
  • Member
  • Member For: 10y 5m 22d
  • Gender: Male
  • Location: Australia

Had two workshops look at this and give up. Diff bushes are new, centre bearing has zero play. They tightened up a bunch of loose stuff (subframe bolts and vibration shield) which didn't fix it. Suggested it could be driveshaft/tailshaft bearings but they didn't want to start replacing stuff hoping it would fix it in case it wasn't the problem. Said it might be best just waiting for it to get worse until it becomes obvious what it is. They didn't charge me as they couldn't figure it out.

Edited by rollex
Link to comment
Share on other sites

  • I'm getten too old for this s**t
  • Bronze Donating Members
  • Member For: 11y 7m 23d
  • Gender: Male
  • Location: A big bridge over a river in South Australia

Didn't you mention the center bearing a while back? ;)

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.



×
  • Create New...
'