Jump to content

I Jet's Bf F6 Ute Build


I JET

Recommended Posts

  • Member
  • Member For: 12y 2m 19d
  • Gender: Male
  • Location: Wollongong

Short test drive this morning to get a wheel alignment done. So nice to drive. Cant wait till I can booooooooooooooooooooooooooooooossssssttt.

2 more days till tune time.......

QcEEkAO.jpg?1

ddg4YNE.jpg?1

398jSLP.jpg?1

  • Like 10
Link to comment
Share on other sites

  • Member
  • Member For: 12y 2m 19d
  • Gender: Male
  • Location: Wollongong

^ yeah mate I will for the time being. Would like to replace them though. You could say the standard boost gauge is pointless.

Link to comment
Share on other sites

  • Member
  • Member For: 12y 2m 19d
  • Gender: Male
  • Location: Wollongong

Well, the results are in. It main 331rwkw and 960nm on 16 pound tapering off to 15 in the top end. I'll be honest, I was expecting this set up to make a little more power but I am in no way disappointed, you cannot argue with how it feels and drives on the street. 4th gear roll on from about 80 km/hr is insane. Really happy with the torque figure. Joe mentioned the ignition timing was holding it back. He did explain it to me very clear on the other readouts, he basically said that he tuned it in closed loop and it was pulling timing out at around 4500rpm due to high intake temperatures. It was nearly 30 deg out there today by the time he was finishing things up. Happy with the result and the service from CMS. The car feels very strong and once it gets on boost it keeps pulling hard all the way to redline. I'm hoping E85 becomes available down here in Wollongong because this will be the next step I think.

m0Y1e5j.jpg?3

  • Like 3
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'