Sub And Amp Install On Factory Icc Bf Ute

[rob94]

My original idea was to have 2 10" subs behind each seat with the amp in the middle but that soon changed when I went to bunnings and they told me they were unable to cut the big sheet of MDF for me, so ended up getting the smaller sheet which was half the size but only $5 cheaper, I got home and re did my box design for a single 10" in the middle of the seats and the amp sitting behind drivers seat and fabbed it up that night. The Amplifier I'm using is a Fusion EN-3004 and the Sub is Sony Xplod XS-L1035. The next day I went to Jaycar and got everything for the wiring,

- 5m 8G Power wire
- High Low converter
- Fuse Holder

- 10m Roll 7.5A Power cable

Power wiring for the amp is as follows:
Positive is run directly from the battery with its fuse just behind the fuse box then run through the clutch cable grommet in the fire wall down under the kick panel and up to the rear speaker then into the Amplifier.
Ground is run to the same grounding point as the rear window de-mister.
Remote is wired to the cigarette lighter.

The High Low converter converts the speaker signal back into a RCA connection making it possible to plug into the amp, it was fairly simple to wire up, Just make sure all your polarities are correct otherwise you will run into problems.

I haven't had any problems with it yet at all, apart from the neighbours telling me to turn it off