Krazy Kyle Get It To Wheelspin Uncontrolably Then Give It Another 5 Pounds Cruise Control 2,697 Member For: 14y 2m 2d Gender: Male Location: Work Posted 31/10/14 11:24 PM Share Posted 31/10/14 11:24 PM put it on my F6 - very little noise difference and no notice in power...... did it in prep for further mods but stock looking. I have a battery/intake relocation kit sitting in the shed that I was going to install but after seeing Murdoks car put out 500rwkw with the standard intake (with muffler delete) I figured stock looking is the go 2 Link to comment Share on other sites More sharing options...
Specs New Member 23 Member For: 10y 9m 29d Posted 02/11/14 12:10 PM Share Posted 02/11/14 12:10 PM gain 17rwhp with my diy turbo side intake stock car no tune just intake and cat restrictor ring removal peak boost with stock intake was 9.7psi with turbo side 10.4 and that's not tuned or fiddled with the psi gain only came from the intake Link to comment Share on other sites More sharing options...
Specs New Member 23 Member For: 10y 9m 29d Posted 02/11/14 01:14 PM Share Posted 02/11/14 01:14 PM ok hopefully this dyno sheet upload works Link to comment Share on other sites More sharing options...
GeGe6 Donating Members 1,978 Member For: 12y 5m 16d Gender: Male Location: Perth, SOR Posted 02/11/14 07:40 PM Share Posted 02/11/14 07:40 PM Got any Pic's of Turbo side intake? Link to comment Share on other sites More sharing options...
ratter Member 6,793 Member For: 18y 6m 26d Gender: Male Location: @ my laptop Posted 02/11/14 10:13 PM Share Posted 02/11/14 10:13 PM would have been ideal to get runs done under the same conditions, if the car has the stock tune or tuned but in closed loop boost control, the boost control will pull the boost back to where it is commanded, but which also varies by rpm and mct, so not unusual to see different boost levels on a stock car when doing multiple runs Link to comment Share on other sites More sharing options...
FORCEDG6E Member 145 Member For: 13y 4m 25d Gender: Male Location: adelaide Posted 03/11/14 10:59 AM Author Share Posted 03/11/14 10:59 AM Extra psi and stock tune is not good Link to comment Share on other sites More sharing options...
Specs New Member 23 Member For: 10y 9m 29d Posted 04/11/14 11:25 AM Share Posted 04/11/14 11:25 AM gained 15ftbs too! and I will grab a pic and would 0.7 psi untuned hurt though as its ment to be 10 stock and its 10.4 atm ford advitised that "overboost" for 10 seconds is 11 psi must be on the autos because mine doesn't gain 1psi for 10 seconds lol Link to comment Share on other sites More sharing options...
Specs New Member 23 Member For: 10y 9m 29d Posted 04/11/14 11:40 AM Share Posted 04/11/14 11:40 AM there was 3 runs done std and 3 runs with the intake about 1-2 degrees different ambient temp with the top std run and top intake run layed over each other on the graph now don't get to excited the intake is pretty basic and I know Im ment to have the oil breather plugged into it but ive just got a large fuel filter plugged in line atm and I will cover it before summer but it doesn't get heat soak unless I idle for 5mins with the thermos going flat out Link to comment Share on other sites More sharing options...
FORCEDG6E Member 145 Member For: 13y 4m 25d Gender: Male Location: adelaide Posted 04/11/14 12:25 PM Author Share Posted 04/11/14 12:25 PM They usally only overboost when trans . kicks down hard. But extra boost and not enough fuel boom Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now