Jump to content

Recommended Posts

  • less WHY; more WOT
  • Site Developer
  • Member For: 16y 8m 29d
  • Gender: Male
  • Location: Melbourne
  On 31/01/2019 at 1:14 PM, MBAF said:

when did you get a new falcoon?

Expand  

this post: https://www.fordxr6turbo.com/forum/topic/88767-gazzas-turbo-build/?do=findComment&comment=1668022

Link to comment
Share on other sites

  • Bronze Donating Members
  • Member For: 13y 5m 18d

Big day. Pulled inlet manifold off, and gave it a clean ready for the plenum.
Modified my fuel reg setup to not use a rail adaptor anymore to clean up the hosing back there.

Found out plenum is not setup well to handle the pcv Valve( plus the inlet had a fair amount of oil in it) so been investigating catch cans.

Where is the best spot to plum the pcv back into?

Link to comment
Share on other sites

  • XR50T
  • Gold Donating Members
  • Member For: 11y 8m 7d
  • Gender: Male
  • Location: Western Sydney

Weld fittings on the rocker cover and use at least -10 lines to a can.

Either vent it or plumb it back to a decent sized port with a check valve so it closes on boost.

If you CBF getting the cover welded you can get drop in adapter's to run AN lines from the rocker cover from speedflow or aeroflow, one of them from memory.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'