Jump to content

Gtx Won't Hold Or Increase Boost.


747pwr

Recommended Posts

  • I see a red door and I want to paint it black
  • Donating Members
  • Member For: 15y 1m 20d
  • Gender: Male
  • Location: Far north queensland

If you are in cairns or townsville shoot me a PM

Also, run the car up on the dyno with only the dump in place, no cat or cat back exhaust.

Edited by sexual harrassment panda
Link to comment
Share on other sites

  • Member
  • Member For: 18y 6m 18d
  • Gender: Male
  • Location: @ my laptop

I have not done a GTX76 but from what I have been told by a supplier, it sounds like you have maxed it out. If the engine is consuming most the air it can pump then there will not be as high boost pressure at higher rpm

  • Like 5
Link to comment
Share on other sites

  • billet turbos and weathered engines dont mix
  • Donating Members
  • Member For: 12y 6m 24d
  • Gender: Male
  • Location: Wollongong

I have not done a GTX76 but from what I have been told by a supplier, it sounds like you have maxed it out. If the engine is consuming most the air it can pump then there will not be as high boost pressure at higher rpm

Same as stock fg but just at a higher power level ratter? I wasn't sure if they were maxing them out on the xrs or not

Link to comment
Share on other sites

  • Member
  • Member For: 18y 6m 18d
  • Gender: Male
  • Location: @ my laptop

I have been told to only expect possibly another 20-30 rwkw above stock unit.

We have to remember that boost is just a measurement of the un used air that the turbo has supplied but the engine can't consume, if the turbo can't supply enough air the boost will be falling over

Link to comment
Share on other sites

  • billet turbos and weathered engines dont mix
  • Donating Members
  • Member For: 12y 6m 24d
  • Gender: Male
  • Location: Wollongong

Here's the turbo. attachicon.gifimage.jpg

Panda I tried to Pm you but it wouldn't work..

Swap you for a GTX 3582 2500 km old? ;)

Will net 480rwkw on e85

Link to comment
Share on other sites

  • Hench, but no longer shredded or tanned.
  • Member
  • Member For: 17y 8m 17d
  • Gender: Male
  • Location: Canning Vale, W.A

I'm glad we have a Workshop owner that actually frequents forums, dime a dozen I tell ya.

  • Like 2
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'