Jump to content

Recommended Posts

  • Hench, but no longer shredded or tanned.
  • Member
  • Member For: 18y 2m 2d
  • Gender: Male
  • Location: Canning Vale, W.A

No worries mate. Well ive ordered a universal one. Surely it wouldnt be that hard to drill a few holes and line it up etc worst comes to worst ill pay someone to fabricate one up for me

  • The Toxic Rocket
  • Donating Members
  • Member For: 15y 1m 5d
  • Gender: Male
  • Location: Brisbane

Literally cut and welded mine to fit. Dad helped out, 2 of the holes fitted up, the other obviously didnt. worked fine and cost me 0 $$

  • You've changed man....
  • Donating Members
  • Member For: 14y 5m 3d
  • Gender: Male
  • Location: 2 Fuchsia Court, Narre Warren. 3805

I modified a universal one.

Bit of heating and bending.

  • Member
  • Member For: 11y 10m 13d
  • Gender: Male

Hey ArronXR, found a pre-made Garret bracket for this exact GTX XR6T swap, $55 from a turbo place on eBay.

You already ordered the universal one? Im gunna buy one now, let me know if ya want the sellers name if you want one.

Better yet maybe wait till I get mine and make sure its exactly the right one.

  • Hench, but no longer shredded or tanned.
  • Member
  • Member For: 18y 2m 2d
  • Gender: Male
  • Location: Canning Vale, W.A

I ordered a universal one for 15$ whats the ebays name? Ill check it out

  • in the mid....not the bum like some
  • Member
  • Member For: 12y 1m 7d
  • Gender: Male

I used a universal one and reinforced it as per reasons above...like you would a accelerator cable bracket.

Make sure on the B series it clears the oil drain/engine mount area.

  • Member
  • Member For: 11y 10m 13d
  • Gender: Male

The bracket is made by Garrett, so I doubt the quality is bad, the place who has them is Automotive Plus in QLD. Phone 07 3863 5858

The guy to speak to is Dave.

Before everyone goes rushing in and buying one I suggest maybe you wait till I get mine and try it to make sure it what he saiz it is.

Mine should be here late this week if not early next week. Also using a genuine Garrett 11.8 psi actuator that I also ordered from him.

Turbine housing is away getting ported so hopefully everything kinda starts turning up at the same time.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'