Jump to content

Ba Xr6 Modded Dyno Figures - Is This Normal?


Bazza96

Recommended Posts

  • I <3 Floods
  • Silver Donating Members
  • Member For: 13y 4m
  • Gender: Male
  • Location: South West QLD

Wow.. that's an awesome comparo there Ratter..

Personally I wouldn't of expected to see a gain in peak power.. I always just assumed that the Underdrive kits just helped the engine rev up a bit easier..

Link to comment
Share on other sites

  • Replies 31
  • Created
  • Last Reply

Top Posters In This Topic

  • I <3 Floods
  • Silver Donating Members
  • Member For: 13y 4m
  • Gender: Male
  • Location: South West QLD

Hey another question Ratter..

Are your power results reading down the page in order of dyno run?

Because if that's the case I'm used to seeing the power increase per run but with the underdrive it looks like it's decreased (Even though it's marginal)

Link to comment
Share on other sites

  • Member
  • Member For: 20y 3m 25d

Hey guys, I have a 2003 BA XR6, with Pacemaker 4495 Extractors 2.5" back exhaust., and a F6 Lower Snorkel for the intake with K&N Panel Filter. (didnt see the money in the growler)

They are the only mods ive done to the car, and I put it on the dyno today to just get a power figure.

I was just using 91 petrol as I filled up when the petrol rocked not too long ago.

I made 152.8Rwkw (204.7rwhp).

Is that normal? Has anyone else seen these figures with those mods?

Im looking to put an underdrive pulley on within the next couple of weeks, can anyone tell me if they do much?(if you have experience).

And are there any other cheapish mods that I can do to gain more power?

Thanks.

The figures seem ok. My car had a 2x2.25 exhaust, growler, under drives and manifold spacers and it ran 160.8rwkw. That was a BF and I was hoping for more. It later ran 175.9rwkw with different extractors and a ported intake manifold.

Link to comment
Share on other sites

  • Member
  • Member For: 11y 10m 15d

Okay, well next week sometime, im going to go get the car tuned on 98. And yes, ill have to run 98 through it all the time.. I know.

But. the guy at Forced Performance and Tuning Toowoomba, said that a underdrive pulley will not affect my tune and that it is okay to do it after a tune. Can anybody tell me if this is true or not before I do this?

Link to comment
Share on other sites

  • Member
  • Member For: 11y 10m 15d

Okay guys, before I do my custom tune.. I wanna make sure everything is done.

I only have a N/A XR6 upper snorkel at the moment, is it worth getting the xr6t/xr8 snorkel? Or is the Typhoon Intake enough?

Also, have heard some rumours, that if I change my oil.. to 5w/30 Syn oil? Could also make a 5rwhp gain?

And Ofcourse, 98 Octane fuel..

If the oil rumour is correct, and 98 gives me a little bit, should send me over 170rwkw?

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.



×
  • Create New...
'