Jump to content

Ba Xr6T Problems


MITCH-JOSH

Recommended Posts

  • New Member
  • Member For: 11y 8m 3d

update: took car for a drive yesterday because it was annoying me just sitting their, still overboosting but engine light didnt come on or go into limp mode, did a few wot's and still fine, will get a full service and scan done this weekend and hopefully all will be fine :)

Link to comment
Share on other sites

  • Member
  • Member For: 15y 5m 19d
  • Gender: Male
  • Location: brisbane

I had this happen to my ba mk2 turned out to be the diaphragm in the waste gate actuator was stuffed. I cut it open and the diaphragm had a hole in it and looked like it had perished due to oil contamination, plus heat from the manifold. You can test for this with an air compressor, just disconnect the signal line from the boost controller and plug it into 15 psi regulated shop air. You shouldn't hear any air leaks and the actuator should move.

Link to comment
Share on other sites

  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'