Jump to content

Starts And Stalls..


jasonxr6t

Recommended Posts

  • New Member
  • Member For: 11y 9m 3d
  • Gender: Male
  • Location: gold coast

Just bought a Ba11 xr6t.

The problem im having is that once its up to running temp, if I let it idle too long say at a set of lights or just in the drivewayit will stall..

Then it will fire back up but stalls imediately.. I have to let it cool for a few min then it will run no prob.. The temp gauge never goes over half way and when I pop the bonnet it doesnt seem too hot.. Im guessing a sensor??

It does have a stuffed wastegate actuator that is causing overboost. Will be putting in a new one this week..

Is it easiest to take the whole manifold and turbo out together or should I just try taking the turbo out??? And is it the overboost problem causing the stalling or something else???

Any ideas would be a great help as im worried every set of light its gonna die....

Link to comment
Share on other sites

  • loitering with intent
  • Lifetime Members
  • Member For: 21y 3m 23d
  • Gender: Male
  • Location: Zombie Birdhouse

could be just about anything. Take it to a reputable tuner and get their say so.

Plugs. coils , throttle body clean ???

Link to comment
Share on other sites

  • New Member
  • Member For: 11y 9m 3d
  • Gender: Male
  • Location: gold coast

Thanks..

I have new coils to put in and plugs aswell. will do them the same time I do the actuator. will clean the tb aswell.

Hope that's the prob! Didnt think it would be the throttle body as it only does it when hot? But anything is worth a try..

Link to comment
Share on other sites

  • New Member
  • Member For: 11y 9m 3d
  • Gender: Male
  • Location: gold coast

Ok , sounds as though cleaning th tb is a good place to start..

Its a little hard to tell if its been tuned, as the actuator is stuffed and it hits the overboost cut. All looks standard. Bought from a dealer in brisbane, they had no idea. And it never stalled till afew days after I got it home.. Really only was able to boot first gear and it didnt cut out, as it was wet and had an old guy sitting next to me. wasnt till the drive home that I noticed the massive boost and it was cutting aroung 3k...

Its a 6 speed manual and has 120k on the clock, motor sounds nice and quiet. Hope I didnt buy a lemon....

Link to comment
Share on other sites

  • New Member
  • Member For: 11y 9m 3d
  • Gender: Male
  • Location: gold coast

Only got a 12 month warranty that covers bugger all. Electrical and the turbo are only covered up to $300 each. Labour to change the wastegate actuator would cost that much. That's why I'm doing that myself, under$200. But if I can diagnose the stalling prob, may get that done under warranty..

Seeing what codes it's been throwing tomorrow so I hope that gives a better idea of what's going on..

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'