Jump to content

Fg Twin 2.5" Vs Single 3.5"


fgxr6t89

Recommended Posts

  • RNS10S
  • Donating Members
  • Member For: 18y 2m 30d
  • Gender: Male

Yeah well mine must have been special! It created 16psi back pressure! Once the 3.5" one was fitted all was good.

Special or not, it supports a hell of a lot more than 320rwkw, mine has over 400 and others are at 450+

Link to comment
Share on other sites

  • Member
  • Member For: 12y 11m 3d
  • Gender: Male
  • Location: Perth

Either a single 90Mm or the twin 63 would be okay but they do produce a different exhaust note. In the early years of the Ford Turbo's the APS system was a single 90 then it ran into into twin 63 at out of the first muffler - and the system was noise compliant.

As for 16 PSI back pressure - that is a lot in an aftermarket system IMO even with the power levels noted. I assume the testing was done at full power?

A rough test on just the rear muffler off the twin 63 Manta shows very low readings (under 2 PSI) but at much lower power levels. I will say the test gear was none too charming but it did show that reading

  • Like 1
Link to comment
Share on other sites

  • I <3 Floods
  • Silver Donating Members
  • Member For: 13y 3m 15d
  • Gender: Male
  • Location: South West QLD

Kosij.. Your twin 2.5" probably was the one that came out with the restrictive rear muffler..

This was fixed in later products..

Edited by Slightly Depressed Panda
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'