Jump to content

My Car Stalled Today


Guest Turbo-6

Recommended Posts

  • Replies 79
  • Created
  • Last Reply

Top Posters In This Topic

  • I see red
  • Member
  • Member For: 22y 8d
  • Location: nowhere in particular

Me and MS700 were talking about this issue yesterday after his car stalled. We find it hard to believe that Ford test these cars before release in high temperatures in Outback Northern Australia, driving them very hard, and supposedly they never had any of these problems whilst a number of us have the problem when not flogging the car and the temp is only in the mid 30s.

My car has only stalled once, not long after I got it. Iwas driving from Bathurst heading towards Blue Mtns along the highway doing 110km/h with CC on and all of a sudden it just died for no reason. Pulled over and tried to restart but the car would not run, it sounded like the carby was flooded to the max or similar, mkissing and pooping and farting. I tried to ring Ford Roadside Assist but had no mobile coverage. It was a high 30 deg temp day. I waited about 5 mins and then tried to restart and it was fine then! Same happened with MS700s car yesterday.

Link to comment
Share on other sites

Guest JasonBriz
  • Guests

I don't believe it is heat related as it has happend mostly on the way to work. 7am and only 5k's from home, the engine is only just warmed up.

Link to comment
Share on other sites

  • It's All In Your Mind
  • Gold Donating Members
  • Member For: 21y 1m 26d
  • Gender: Male
  • Location: Melbourne
I don't believe it is heat related as it has happend mostly on the way to work. 7am and only 5k's from home, the engine is only just warmed up.

;)

COMPUTER GREMLINS ME THINKS. TRY DISCONNECTING THE BATTERY FOR HALF AN HOUR. WORKED WONDERS FOR MY T :thumbsup:

Link to comment
Share on other sites

Guest rabbit
  • Guests

I've been complaining about this for 6 mths. Ford have advised there's an ECU update due in late January that should correct this problem. Start annoying your dealers now.

Link to comment
Share on other sites

  • Xtreme Xalted Member
  • Donating Members
  • Member For: 21y 7m 19d
  • Gender: Male
  • Location: BrisVegas

Jayses,

I know this bloody story backwards and sideways.

I can be certain of a stall at least once a week.

No pattern other than when in traffic or other slow speeds. Not heat or air/con related.

It has happened since new right through to 26k. Local dealer cannot fix so I'm hopeful that the rumoured upgrade will fix the problem.

Till then, #@**+*#!! and :spit:

Link to comment
Share on other sites

  • Donating Members
  • Member For: 21y 7m 25d
  • Gender: Male
  • Location: Brisbane

Mine stalled on a very hot day in Brisbane recently, power steering went as I was taking a left hand turn I thought sh*te whats happened here. I took into the dealers last Friday, they tell me they updated the ECU with the latest version of software which they told me will overcome this problem. So far so good but only early days.

Does anyone know how you can tell the version of software installed in the ECU?

Link to comment
Share on other sites

  • What's happening?
  • Lifetime Members
  • Member For: 22y 21d
  • Gender: Male
  • Location: Steel City, NSW

Mine hasnt stalled (recently <_< ), but what has been happening a lot is the revs dropping to a point where the fire almost goes out.

Situation: Pulling up to a traffic light, slowing in 2nd (manual) with brakes. As I come to a stop, press clutch in (while still rolling) revs drop below 500RPM, and then the ECU realises its about to stall and blips it back up to 1500odd before settling to idle. You can actually feel the controls (steering, brakes)lose their power assistance as the engine almost dies.

It has only started happening recently, which seems to coincide with the permanent use of the AC in the weather we have had since before christmas.

Havent had a chance to have it looked at yet, but I am hoping that the ECU update will address.

Link to comment
Share on other sites

  • Member
  • Member For: 21y 2m 9d
  • Location: Hills, hills and more hills = Brisbane

Is this problem happening on cars that have done over a certain mileage? I'm wondering if its part ECU and part mechanical, such as some buildup of crap in the idle stepper or similar?

The fault sounds almost like given a certain scenario the ECU is trying to close the stepper motor too quickly and thus it stalls.

Does anyone who has had the ECU software upgrade know if it takes longer to settle back to idle than it did before?

Cheers

Brett

Link to comment
Share on other sites

  • Formerly Turbo6
  • Donating Members
  • Member For: 21y 11m 17d
  • Location: North Brisbane

Hunting idle and stalling - same here.

With regards to the crap buildup, I made Metro Ford pull out my phasers and clean all the actuators because I was really getting peeved about it. Whether they did it or not is a little bit of a mystery because it is still as bad as ever................ <_<

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.



×
  • Create New...
'