Livelink Gen-11

[Yortt]

Has anyone used the new Livelink Gen-11 scanner software and if so have you had any success geting the histogram to work?.

I have tried and can only get the counts to work on an FGXR6T!

[IH8TOADS]

Yes. If it doesn't work I just do a log with LL6.5 on my logging laptop and then save the file to .csv. I then open the file with GenII and configure the histogram and re-play. Works like a charm. The xcal2 and BA don't seem to like GenII so this is how I get around it.....it's not live but I can make it serve my purpose.

[Yortt]

Yes. If it doesn't work I just do a log with LL6.5 on my logging laptop and then save the file to .csv. I then open the file with GenII and configure the histogram and re-play. Works like a charm. The xcal2 and BA don't seem to like GenII so this is how I get around it.....it's not live but I can make it serve my purpose.

Buggered if I know what I am doing wrong tried that way! will have to go over the steps again, there is not a lot to set up and appears very little to go wrong but I can only fill the histogram with counts nothing else works, anyway thanks for the reponse.

[IH8TOADS]

An unmodified .csv logged with earlier livelink should open in GenII. Did you log lowercase or uppercase parameters?

[Yortt]

An unmodified .csv logged with earlier livelink should open in GenII. Did you log lowercase or uppercase parameters?

I used some lowercase and some uppercase, I read somewhere uppercase should be used, what is the significance?

It is difficult to determine which is the correct pid to use.

The ones I want to log are:

LOAD_FROM_MAP (several to choose from not sure what the difference is)

SPKADD_AVG_ALL (knock retard seems to work ok)

RPM (seems to work ok)

INJECTOR PULSE WIDTH (Appears not to have a pid for this)

On the chart screen they display fine on the histogram it will only show the count

Edited 16/11/12 09:45 AM by Yortt

[IH8TOADS]

Some basics

RPM

LOAD

BARO_PRESSURE

MANIFOLD_ABPRES

WASTEGATE_DUTYCYCLE

BOOST_DESIRED

BOOST_ERROR

TP_RELATIVE

SPARK_ADVANCE

SPKADD_AVG_ALL

COOLANT_TEMP

AIR_CHARGE_TEMP

FUEL_PW_CLKTIC

LTFT

STFT

.....is what they show logged. I cut and pasted this from another post I made.

You need to configure the histogram

[Yortt]

Thanks for that list of pids , I have configured the histogram in various configurations and will still only show counts, hopefully with this list of pids it will now work.

Can anyone tell me what the significance/difference of upper and lower case pids are?

Can anyone tell me which option should be used and under what circumstances the other two option would be used?

• Use previous list of pids if available (validate all other pids otherwise)
  
• Validate all pids in list
  
• do not validate pids
  

Thanks!

[IH8TOADS]

Upper case are ford specific direct memory requests. Lowercase are generic PID garbage.

[Yortt]

Ok Thanks!