Cooler For Under 400Rwk

[Kroozin]

if you have the cooler that goes a beez dick under the airbag sensor then the brackets that go up are only like <50mm long.

If ya paint them black ( think the plaz ones come black anyway) you will never see them unless you remove the upper grill or look too hard.

[tonyv]

I have the plazmaman pro series 700hp kit. perfect for 390-410rwkw

Edited 11/10/12 09:05 AM by tonyv

[ratter]

Plazmaman rate their 800 hp cooler good to 380 rwkw, so the 700 would be lower than that

[bionicxr6t05]

Yeh I have the big plaz 700 as well... Makin 400rwkw but I dont think itl push much more consistantly...

[PSI O6T]

Might go and talk too the guys at hdi, local to me and im thinking for what I want will do the job well, not too sure how the cold side runs though.

Also what cold side piping fits the hdi coolers?

May have to mix n match

[GTEXXED]

Rapids is only 1k bloke and craps on the hdi.the hdi coolers sit very low also.

[PSI O6T]

is this the kit you are talking about GTEXXED , is that the size cooler in the pic ,it looks rather large....

http://i303.photobucket.com/albums/nn134/tresurehunt/Capturek.png"]http://

[Process West]

  On 11/10/2012 at 5:51 AM, tresurehunt said:

is there a cooler that fills the top section instead of running those hideous drop down straps or could you just make 2 small brackets off the bumper rio...

My stage 1 and 2 intercoolers do not have the straps that come down....uses the factory mounting points.

Kev

[Bellato]

^^ This and you don't need to cut anything with the stepped cooler

EDIT: don't worry I was thinking FG!

Edited 14/10/12 12:45 AM by Bellato

[PSI O6T]

  On 14/10/2012 at 12:30 AM, Process West said:

My stage 1 and 2 intercoolers do not have the straps that come down....uses the factory mounting points.

Kev

much cutting involved ?

whats power is the stock crossover good for ?