Jump to content

Bi Model Exhaust On 2011 Gtp.


ilco22

Recommended Posts

  • Donating Members
  • Member For: 12y 4m 10d
  • Gender: Male
  • Location: Doreen

Make sure you disconnect the vaccuum T peice at the back. Unplugging the plug on the firewall costs you KW's.

Yeah ill definitely do the one above the muffer. Just want to make sure I remove/block the right one...

Link to comment
Share on other sites

  • Member
  • Member For: 21y 5m 10d
  • Gender: Male
  • Location: Newcastle

You will see some tubes with a plastic t-piece like in the pic below. Disconnect as shown and use a small bolt to plug up the hose, use a bolt that is a little bit thicker than the inside diameter of the hose for a good seal. You can zip tie the hose so the bolt stays in there if you wish.

Benny.

post-1744-0-32786100-1348958812_thumb.jp

Link to comment
Share on other sites

  • Donating Members
  • Member For: 12y 4m 10d
  • Gender: Male
  • Location: Doreen

Disconnected it and got a guy from work to do a few drive by's for me. tough sound!... I reckon an aftermarket exhaust would sound better though. This will certainly do for now.

  • Like 1
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'