JMF Member 8 Member For: 14y 8m 16d Posted 25/09/14 02:18 PM Share Posted 25/09/14 02:18 PM For the front I've had new front discs, pads and reconditioned callipers about 9 months ago, about 2 weeks ago both lower ball joints and also the steering rack which was clicking and needed changing anyway apparently and the wheel bearings were checked and the booster rod as well. For bushes have only had a new one for the diff but none in front. It happens around 90-100 when the cars been running for at least 5 minutes and at constant speed, the last time I had been at 95-100 for 5kms. I've had times when it's been fine on the freeway drive from home to just north of Perth which is 15-20 mins and done it on the way back but its also happened on the way out and not on the way back. Tremble in steering wheel to shaking violently takes maybe 45secs -1 min and I slow down pull over and stop and best way I can describe the shake severity is you have to grip the steering wheel very tight with both hands to keep it straight even while it's slowing down am no way car cluey but guessing this is how warped discs would feel. I'll report back if/when I find out Link to comment Share on other sites More sharing options...
barnz Member 3,047 Member For: 10y 11m 23d Gender: Male Location: Brisbane Posted 26/09/14 10:32 AM Share Posted 26/09/14 10:32 AM (edited) The violent steering wheel shake indicates its definitely front end related and bushes as mentioned would be a good place to start. Discs will continue to warp very quickly if there are underlying issues. Wheel bearings, worn control arm bushes ect.Warped front discs will make the wheel shake but usually not to the point where you feel like pulling over and should pretty much go away when the brakes are released.Get it into a good suspension place and get it sorted, then get your discs machined if they arent that old.Also as mentioned a sticking caliper could be the cause but you did say you've had them rebuilt, if you have a cheap inferred thermometer you could see if any one of the rotors is generating an unusual amount of heat when the shaking starts. Just to double check. Edited 26/09/14 10:37 AM by barnz Link to comment Share on other sites More sharing options...
Ralph Wiggum Moar Powar Babeh Lifetime Members 19,323 Member For: 19y 1m 20d Gender: Male Location: Perth Posted 26/09/14 11:07 AM Share Posted 26/09/14 11:07 AM It's a vicious circle, brake shudder may intiate the wobble but worn out front bushes will increase it and prevent it from stopping. Link to comment Share on other sites More sharing options...
JMF Member 8 Member For: 14y 8m 16d Posted 26/09/14 12:46 PM Share Posted 26/09/14 12:46 PM OK thanks am in saving mode again now but when I take it back in will ask for these as first to be looked at. Will have to be the Focus for any freeway trips for a while Link to comment Share on other sites More sharing options...
bjc Donating Members 2,823 Member For: 21y 2m 9d Gender: Male Location: Townsville Posted 27/09/14 12:18 AM Share Posted 27/09/14 12:18 AM Front tyres will be out of round now also due to the failed lower and upper control arm bushes which makes it worse again! I had brand new tyres all round and it failed on me on a drive back from Mackay to Townsville (400km). Tyres are completely farked even though looking at them you'd think their ok until you use them.... Link to comment Share on other sites More sharing options...
Falcon SXR8 New Member 3 Member For: 12y 6m 1d Posted 29/09/14 04:00 AM Share Posted 29/09/14 04:00 AM My ba had the shudder coming on after driving for a bit and it was the brake booster, had it " adjusted " still no good so chucked it and put a new one on and been fine ever since. Link to comment Share on other sites More sharing options...
JMF Member 8 Member For: 14y 8m 16d Posted 30/09/14 11:32 AM Share Posted 30/09/14 11:32 AM Just been looking around sites at prices for the booster and control arm bushes costs and they're not ridiculously expensive so if it's either one of these it's not gonna break me but will see what the mechanic reckons on labour for either/both of these. Have had the car for 4 years is that a good innings for front bushes normally? Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now