Jump to content

Recommended Posts

  • Replies 22
  • Created
  • Last Reply

Top Posters In This Topic

  • 3 weeks later...
  • Donating Members
  • Member For: 12y 10m 1d
  • Gender: Male
  • Location: Newcastle, NSW

if you have a hardlid start there. My ute had a squeak and thought it was the leafs or bushes but ended up being the hardlid not being held down tight enough and was slightly moving around. little adjustment on the latch points and shes all good :sungum:

  • New Member
  • Member For: 14y 9m 24d

You ALL have bent axles!

The sound your hearing is the brake pad rubbing on the disc because the axle is out of alignment...... Too much wheel spin gives off diff tramp which slightly bends axles... even a big pot hole will do it

  • Thooperrrrrrr
  • Donating Members
  • Member For: 13y 10m 3d
  • Gender: Male
  • Location: NOR, Western Australia

Sometimes they break, which makes them vibrate when going over bumps which is the noise you hear.

Replacing them stops them vibrating as they're pushing properly against the inner wall

  • New Member
  • Member For: 14y 9m 24d
  On 22/09/2012 at 10:33 AM, cizzink11 said:

My question was a sarcastic one lol. If it were bent axles I would still be annoyed right now.

You may have reset the pads, which in the short term might stop the squeak. IT will be back!

When the diff is under load or going around a corner that puts the most strain on the axles.

Ive had axles replaced and only to find it happening again after a bit of sideways action.

  • Donating Members
  • Member For: 15y 3m 17d
  • Gender: Male
  • Location: Christchurch, New Zealand

He's just trying to bait us into saying we have done illegal acts like himself. Must be cop.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.



×
  • Create New...
'