Jump to content

The What's Pi$$Ing You Off Thread


EFSIX

Recommended Posts

  • I see a red door and I want to paint it black
  • Donating Members
  • Member For: 15y 16d
  • Gender: Male
  • Location: Far north queensland

working on reports past midnight when I start the next job at 4am, then work til 5pm and drive over 4 hours to the next site.

if only I had time to apply for other jobs

Link to comment
Share on other sites

  • I <3 Floods
  • Silver Donating Members
  • Member For: 13y 3m 10d
  • Gender: Male
  • Location: South West QLD

Engineers.

BLAH BLAH BLAH.. I Blame the seniors cause I'm crappy at my job..

Then, as it was 2 months ago... Telstra.

After getting the internet connected, and it being connected at 2.4mb/s instead of the 20+ we're meant to be on, we have now received a letter from debt collectors asking for a bill to foxtel and their equipment back.

Telstra didn't finalise the account properly so my partner has a strike against her name again.

When they connected my phone, they connected it to the RIM which is correct (its about 300m from my house) but instead of going direct to the RIM and through the Top Hat upgrade they have on it, we were put through it and back to the exchange 4.5kms away (hence slow speeds). Mate is trying to get this fixed but no-one at Telstra has any idea what I'm talking about. Spoken to about 6 different tech support guys and they all say different things.

Telstra are a fking mob of knobs.

Fk you..

Link to comment
Share on other sites

  • Thooperrrrrrr
  • Donating Members
  • Member For: 13y 4m 8d
  • Gender: Male
  • Location: NOR, Western Australia

Fk you..

Lmao

The amount of times engineering have sent us the wrong drawings for the job too is ridiculous.

Some of the new TA's don't check the drawing numbers either so unless we pick it up, potential rebuild of the whole lot.

Link to comment
Share on other sites

  • I <3 Floods
  • Silver Donating Members
  • Member For: 13y 3m 10d
  • Gender: Male
  • Location: South West QLD

Ahh yes.. But you're talking about TA's.. Not engineers.. We can't be help responsible for Cad monkeys..

(Though there is a reason I do most of my own Cad)

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'