Jump to content

Recommended Posts

  • XR50T
  • Gold Donating Members
  • Member For: 12y 1m 21d
  • Gender: Male
  • Location: Western Sydney

Fitted a farken big setrab engine oil cooler and 10" fan. Used a mocal thermostatic sandwich plate with -10 lines.

No pics cos bloody fan thermo sensor decided to started leaking.

  • Like 3
  • Silver Donating Members
  • Member For: 17y 7m 13d
  • Gender: Male
  • Location: left right out

Fitted a new rubber exhaust hanger, only took 10 days for them to get one in ffs.

Still, probably the cheapest genuine FPV labelled part you can buy at just $10.

  • Like 1
  • Dropping a turd
  • Gold Donating Members
  • Member For: 17y 7m 26d
  • Gender: Male
  • Location: Perth
  On 30/11/2015 at 9:38 AM, GeGe6 said:

Went more stock cause stock is in.

bf1ac191eeed2279e5eb0ff6521546c0.jpg

Haters goings to Hate hate hate.....lol

STOCK is

HOOMO

Edited by arronm
  • Like 1
  • Manual mode ________________________ All day, erryday
  • Donating Members
  • Member For: 17y 6m 29d
  • Gender: Male
  • Location: Probably above atmospheric pressure

Stuck the Project Mu pads in finally, car still stops so that's good. Remsas were about 2/3 gone and getting hell screechy.

Scabbed a sauce packet of caliper slide pin grease off the dirt next to Kyle's driveway (unused from his last set of pads), so thrifty.

0tlPKEK.jpg

Dunno about the colour scheme but them's the...

.....brakes

YEEEEEEEAAAAAHHHHHHHH

  • Like 4
  • Donating Members
  • Member For: 21y 9m 19d
  • Gender: Male
  • Location: Townsville

"Guys" are called ho mos! It's either "bloke" or "this Cnt"...

Can't even type fa ggot now.... wtf!!!?

Edited by bjc
  • Moar Powar Babeh
  • Lifetime Members
  • Member For: 19y 8m 30d
  • Gender: Male
  • Location: Perth

I wasn't happy with the amount of heat building up inside the bumper (and the time it was taking for the temp to come down) since installing the A2O trans cooler. I'd seen a few hack jobs to vent the inner gaurd but decided this wasn't for me so I wound up sourcing an ally vent/louvre Panel. Was quite easy to install and once the thermo on the cooler kicks in the heat comes pumping out of it. Im considering adding an additional vent above this one so the entire cooler surface has access to a vent but will see how this perfoms first. Fresh paint/camera flash makes it look a light louder than it is. Once a bit of road grime has made itself at home I doubt you'll be able to see it at all.

post-7403-0-53948700-1450788796_thumb.jp

post-7403-0-40616600-1450788803_thumb.jp

  • Like 4

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'