Jump to content

Recommended Posts

  • Silver Donating Members
  • Member For: 12y 6m 18d
  • Gender: Male
  • Location: Griffith NSW

One of those things I wish I bought before it broke. Plus found a squirt of oil in the footwell so guessing the unit it stuffed. Calling Mal in the morning to Express ship me one of their units.

  • Gold Donating Members
  • Member For: 10y 2d
  • Gender: Male
  • Location: Canberra ACT

Finally replaced the blade arms. No wonder the rear felt like rubbish on the Snowys trip - I can wiggle the mounting brackets in the old arms by hand very easily.94cddcc4c580b6017d6154dd51445c42.jpg

  • Like 3
  • Donating Members
  • Member For: 10y 7m 19d
  • Gender: Male
  • Location: Mundaring

Went roll racing tonight and the box stopped shifting into 3 quickly at high rpm and just looses boost instead

  • Sad 1
  • Silver Donating Members
  • Member For: 12y 6m 18d
  • Gender: Male
  • Location: Griffith NSW

Malwood master cylinder went in last night. 0% plastic Beautiful!

Then dropped it off today to have the rust in the passenger door sill fixed. Hopefully his autopsy tomorrow doesn't come back too dire

  • Like 1
  • Sad 1
  • Member
  • Member For: 6y 4m 20d
  • Location: New zealand

Haven't done it yet but going to put 2 saas guages in car, after a lot of thought I got 2 saas single guage cups with the mounting stand. I'm going to put a boost guage to the right of the dash between the airvent and the dash and a engine oil temp just to the left of the dash, I think it will be pretty tidy and easy to see too. So when my oil temp comes up it's safe to start boosting it. I bought a saas twin guage pillar mount pod but I dont like it cos it cuts the visibility down too much, the guages stick out too far. 

  • Like 1
  • Donating Members
  • Member For: 5y 9m 2d
  • Gender: Male
  • Location: Cairns

Shouted the FG XR6T ute a new DIY Hardy Spicer centre bearing, other one was 50% torn.

Realigned shafts as they were previously and only good vibrations going on. 

For the record was 11mm offset 35mmm shaft and 170mm bolt centres.

Edited by Wyatt
Added
  • Like 1
  • Silver Donating Members
  • Member For: 6y 9m 17d
  • Location: Carnarvon

Just picked up the Bluetooth dongle for my Valentine One detector.

 

Didn't even know these things existed otherwise would've had one years ago.

 

Using the jbv1 app, awesome bit of kit.

 

Oh wait most members here can't use one --> NaNaNaNa!!:gaming:

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'