Jump to content

What Did You Do To Your Car Today?


Henz

Recommended Posts

  • Member
  • Member For: 19y 10m 3d
  • Location: sydney

After being out of an xr6t for 2 years I picked this up a couple of weeks ago

is a manual with leather and only 34,500kms

 

IMG_4401.JPG

 

 

Don't know why the the image posted sideways 

Edited by will-82
  • Like 1
Link to comment
Share on other sites

  • Manual mode ________________________ All day, erryday
  • Donating Members
  • Member For: 16y 11m 26d
  • Gender: Male
  • Location: Probably above atmospheric pressure

Yeah car being sideways doesn't count if you just rotate the pic man hahaha

Link to comment
Share on other sites

  • Member
  • Member For: 8y 5m 3d
On 08/02/2017 at 1:39 AM, Ralph Wiggum said:

Shibby....

 

gc14UvA.jpg

 

J6rypi1.jpg

 

BAjJarx.jpg

2dbADo8.jpg

4r7bffM.jpg

 

Another couple of hours Tomorrow night and she'll be rolling again. 

looking good man, just be interested to get that drive!

 

you need more subframes, get them welded on, powdercoated and  then boom bolt in change overs

  • Like 1
Link to comment
Share on other sites

  • 2 weeks later...
  • Donating Members
  • Member For: 16y 7m 15d
  • Gender: Male

Changed the inlet manifold gasket last night - fun!

Been having issues with cold starts and a P2110 error (throttle actuator control system)

On some cold starts it would rev to 2k then drop to 1k and run like a POS. Switch ignition of and on then would be fine for the rest of the day. Other times cold starts would see revs fluctuate between 1k and 2k till warmed up - bit all over the shop.

Happy to say after replacement it kicked over first go from a cold start to a nice steady idle. Is now running much smoother than before.

Guess the giveaway was when the old gasket fell into 3 pieces when taking out.

  • Like 1
Link to comment
Share on other sites

  • Bronze Donating Members
  • Member For: 13y 3m 29d

Fellas I bought a ba XR6 and I'm puzzled.

Problem.
Ba XR6 intermittently cuts out. Starts then throws engine light and then goes into a limp mode and turns off.
If I don't cycle the key it won't restart as the engine light is on.
Cycle the key and its starts and runs for anywhere between 2 seconds and 10 minutes.

Only code is p0351 which is coil 1. Moved coil 2 to 1 and put a second hand coil into 2. Code still exists on coil 1.

Help needed big time.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'