JETURBO ...JD TUNING ADELAIDE... Gold Donating Members 23,708 Member For: 16y 6m 21d Gender: Male Location: Adelaide Posted 25/07/16 12:33 PM Share Posted 25/07/16 12:33 PM You guy's called for me ? 4 Link to comment Share on other sites More sharing options...
stubbietubbie Filthy weeb Member 1,870 Member For: 11y 10m 6d Gender: Male Posted 25/07/16 12:53 PM Share Posted 25/07/16 12:53 PM (edited) No, butt out of it and stop plugging Jonny Tig. Edited 25/07/16 01:00 PM by stubbietubbie FOR EMPHASIS, FOR CLARITY, FOR HONOUR Link to comment Share on other sites More sharing options...
BAXRTUTE Gold Donating Members 2,639 Member For: 8y 8m 4d Posted 25/07/16 12:58 PM Share Posted 25/07/16 12:58 PM Did the Plugs 3 wks ago... Ive got a miss that wont go away, No codes... changed everything I can think of and no change! Mainly happens under half throttle from 3k rev then kicks into gear, car shutters. Also happens sometimes at full throttle but not all the time. Been a head fark Link to comment Share on other sites More sharing options...
JETURBO ...JD TUNING ADELAIDE... Gold Donating Members 23,708 Member For: 16y 6m 21d Gender: Male Location: Adelaide Posted 25/07/16 01:03 PM Share Posted 25/07/16 01:03 PM Check the wiring on the camshaft position sensor plugs ( back of engine left and right ) up top but just under the rocker cover area 1 Link to comment Share on other sites More sharing options...
BAXRTUTE Gold Donating Members 2,639 Member For: 8y 8m 4d Posted 25/07/16 01:15 PM Share Posted 25/07/16 01:15 PM Will do tomorrow chief, hope your right cause new coils, plugs, turbo intake alterations havent helped it. Its like the turbo is starving of air, first thoughts was the under battery iintake but piping is fine. Just need to get my sh*t together and get a certain order happening and in the car Link to comment Share on other sites More sharing options...
Box stock T. Member 1,384 Member For: 9y 8m 15d Posted 30/07/16 05:43 AM Share Posted 30/07/16 05:43 AM Spent the morning fitting a new Venom bolt on cat section (two piece for the BA /BF) The bolts between the centre muffler and middle pipes were a bit of a struggle, but got there with a bit of raw grunt. Also put the cross over and pipes back on after installing new coils. Oil and filter next weekend then it's off to JD tuning for injectors and wastegate actuator upgrade. Link to comment Share on other sites More sharing options...
arronm Dropping a turd Gold Donating Members 9,520 Member For: 17y 1m 25d Gender: Male Location: Perth Posted 30/07/16 05:47 AM Share Posted 30/07/16 05:47 AM Half way through mechatonics , seal change. But stopped for lunch. Link to comment Share on other sites More sharing options...
Trent0 The Toxic Rocket Donating Members 574 Member For: 14y 7m 27d Gender: Male Location: Brisbane Posted 30/07/16 09:26 AM Share Posted 30/07/16 09:26 AM On 21/07/2016 at 8:33 AM, JETURBO said: Yeh I'm sure it was sold as a roller hey 425 sounds about bang on for the stock turbo so good results, who tuned it ? I bought it as a roller 2 years ago and we put it all the bits in it to get it going again. Forced Performance Tuned it Link to comment Share on other sites More sharing options...
arronm Dropping a turd Gold Donating Members 9,520 Member For: 17y 1m 25d Gender: Male Location: Perth Posted 30/07/16 09:56 AM Share Posted 30/07/16 09:56 AM Job done, test driven and back on the hoist to check for leaks in the morning.. Link to comment Share on other sites More sharing options...
bloodycrashboy Feeling the Love :-) Bronze Donating Members 4,421 Member For: 11y 8m 21d Gender: Male Location: Not in Cairns anymore Posted 30/07/16 10:17 AM Share Posted 30/07/16 10:17 AM did oil and filter this morning. no hoist just 2 plastic ramps up front to allow this grumpy old man to get down and dirty. 1 hour start to finish (not bad for an old bastard) drove up the Karanda range to Mareeba to watch a round of the Aussie Supermoto champs. I know it is a psychological thing, but the car always feels better with all that new oil goodness. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now