Jump to content

What Did You Do To Your Car Today?


Henz

Recommended Posts

  • Donating Members
  • Member For: 12y 5m 5d
  • Gender: Male
  • Location: Perth, SOR

Do you know what ths width is? Does it say on the box perhaps?

https://www.autobarn.com.au/explore-level-caravan-3-step-pair-cvl1

Assume it's that one ^^^

Thinking I should get a pair instead of using the bricks... And a pair of axle stands for the 4 times a year that I change my wheels lol

About 200-250mm at best guess.

Link to comment
Share on other sites

  • Donating Members
  • Member For: 11y 6m 16d
  • Gender: Male
  • Location: NOR Perth

Yeh I knew that (widest I could find was 250mm). But apparently fine to have a little overhang.

Cause its on the cheaper side I'll guesstimate 210mm....so 35mm overhang each side wont be so bad

Link to comment
Share on other sites

  • Feeling the Love :-)
  • Bronze Donating Members
  • Member For: 11y 8m 11d
  • Gender: Male
  • Location: Not in Cairns anymore

Do you know what ths width is? Does it say on the box perhaps?

https://www.autobarn.com.au/explore-level-caravan-3-step-pair-cvl1

Assume it's that one ^^^

Thinking I should get a pair instead of using the bricks... And a pair of axle stands for the 4 times a year that I change my wheels lol

They are 200mm wide, though you will need something to chock behind the tyre to stop it rolling backwards.

I'm going back to autObarn tomorrow to look at the plastic items that fitted in the slots of the ramp.

They were $17 and I thought that was a bit pricy for plastic chocks.

But if they look like they will be more functional than a piece of timber, Ill buy them.

  • Like 1
Link to comment
Share on other sites

  • Feeling the Love :-)
  • Bronze Donating Members
  • Member For: 11y 8m 11d
  • Gender: Male
  • Location: Not in Cairns anymore

Handbrake doesnt work? I always have one rear wheel on the ground

Always better to be safe than sorry.

when I have the rear on stands I still keep the trolley jack there with a little weight on it and front wheels chocked.

Link to comment
Share on other sites

  • Silver Donating Members
  • Member For: 10y 10m
  • Gender: Male
  • Location: SW Sydney

Serviced the ute today

Used semi synth nulon for the first time...full synth something fg cam wear something something :ermm:

Decided that I'll alternate between the two

Also made a couple of new bar supports for the tonneau cover

For the last few years I've left it open as all too often carting something around a bit high and got sick of taking it off (also why never got a hard lid though love the look of them)

At some point lost the bars and even with a house move haven't tracked them down. Have seen them on ebay for around $90 delivered - each. Screw that. No doubt Ford would be the same/more.

Borrowed the bars off a mate's uncle's ute and made up a couple in staino.

Only thought afterwards of the wrecker option but done now. Plus making stuff = win ;)

post-77265-0-21177500-1451733387_thumb.j

Edited by camo86T
  • Like 3
Link to comment
Share on other sites

  • New Member
  • Member For: 9y 6m 14d
  • Gender: Male

c300378c3588c9b389f33158aab2615a.jpg

Towed a boat!

Also celebrated the new year with my rear tyres traveling faster than my front tyres for a short period

On a private road of course

How'd you go towing the boat? Is your FG auto or manual?

Only reason I ask is that my father in law has given me a boat similar size and I am debating weather to put a towball on my FG ute or get a cheap 4wd to tow it.

What did I do to my car today( or over the last 2 weeks)?

Painted and fitted a XR8 bonnet

Fitted some 6.5" Hertz speakers to front doors and covered the door in Dynamat

Discovered rear speakers have been swapped for some JL Audio 2ways. Pulled them out and put a heap of Dynamat behind there.

Fitted a slim line 12" Kicker sub and amp

Chucked on a SS Inductions BigMouth CAI.

Painted the middle bottom section of the front bar black.

Next up is paint the wheels black, apart from the sh*t offset on the FG ute I really like the look of the stock Snowflake rims. Still undecided on lowering or not, I hate seeing the big gap in the wheel guards but on the other hand I bought the ute to get dirtbike about and low utes on bumpy gravel roads suck.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'