"Captain Retard" Member 1,417 Member For: 10y 6m 19d Gender: Male Location: Shellharbour NSW Posted 22/09/14 01:13 AM Share Posted 22/09/14 01:13 AM (edited) . Rislone Rear Main Seal Repair (p/n 34250) is a unique blend of polymers, lubricity agents, anti-oxidants and conditioners that restores seal size, flexibility and elasticity. Chemical polymers in the product also fill in gaps and grooves in the crankshaft caused by normal engine wear, and build a protective film around the seal to prevent leaks.The companies been around for over 90 years.Looks like it's some sort of seal conditioner.Will wait until next oil change and then rethink it. Edited 22/09/14 01:14 AM by "Captain Retard" Link to comment Share on other sites More sharing options...
Ralph Wiggum Moar Powar Babeh Lifetime Members 19,323 Member For: 19y 1m 29d Gender: Male Location: Perth Posted 22/09/14 01:20 AM Share Posted 22/09/14 01:20 AM . Chemical polymers in the product also fill in gaps and grooves in the turbocharger bearing pack causing loss of lubricationAre you sure Link to comment Share on other sites More sharing options...
"Captain Retard" Member 1,417 Member For: 10y 6m 19d Gender: Male Location: Shellharbour NSW Posted 22/09/14 01:43 AM Share Posted 22/09/14 01:43 AM No........no I'm not, in fact very unsure.Wish I'd tried this product out on my old Camrys, they used to piss oil out everywhere, but I didn't really care cause Camry! Link to comment Share on other sites More sharing options...
Gee-dog Member 27 Member For: 10y 7m 14d Posted 22/09/14 05:35 AM Share Posted 22/09/14 05:35 AM Ralph mentioned it could be the top two bolts (Torx bit, T40?) that have 90% flogged out no longer pulling cover down enough. He's probably right, so: -Decided to remove the cooler piping hangers that are spacing those those bolts out a couple mm and reducing the thread in the head they are grabbing. I had my timing cover off last week to reset the chain - it had jumped a tooth. When I bolted the cover back on one of these bolts (the one that goes through the turbo pipe tab) didn't tighten at all - it just kept turning with very little resistance.I bought a longer bolt (8mm x 1.25, 150mm long, hex head) and a 150mm long 8mm tap (had to get this made - actually got 2 - one tapered & one plug). I extended the threaded section of the bolt a bit, using a die (already had this), then tapped the hole in the head to take the longer bolt. Did all this without removing the front cover again, so worth the $ buying taps in the time & effort saved.My timing cover was leaking before as well, but when I removed the harmonic balancer it seems that the leak was from the front crankshaft seal. This can be replaced without removing the front cover, but you do have to take the balancer off. I had the cover off to reset the chain, so replaced it off the car. Link to comment Share on other sites More sharing options...
.Stripes. All stock bar the k&n panel filter Silver Donating Members 8,061 Member For: 12y 8m 8d Gender: Male Location: Perth Posted 25/09/14 08:38 AM Share Posted 25/09/14 08:38 AM Fitted up my Rspec rears with some 275 Dunlop sport maxx tyres...I know my car's only stock but new tyres hold all of every gear without wheelspin even with traction control turned OFF.Is it just me though...or is anyone else's OCD tingling?... 2 Link to comment Share on other sites More sharing options...
Never had any say Panda I <3 Floods Silver Donating Members 11,198 Member For: 13y 3m 21d Gender: Male Location: South West QLD Posted 25/09/14 08:44 AM Share Posted 25/09/14 08:44 AM Are the stripes different on each side?That'd send my OCD straight for a noose..Time for 275 fronts! Link to comment Share on other sites More sharing options...
.Stripes. All stock bar the k&n panel filter Silver Donating Members 8,061 Member For: 12y 8m 8d Gender: Male Location: Perth Posted 25/09/14 08:46 AM Share Posted 25/09/14 08:46 AM Stripes are fine. Try again... Link to comment Share on other sites More sharing options...
MattyP MattyP Cruise Control 6,317 Member For: 12y 6m 17d Gender: Male Location: Central Coast Posted 25/09/14 08:48 AM Share Posted 25/09/14 08:48 AM Wheels not sitting perfectly up and down And that's a sh*t hot car stripes 1 Link to comment Share on other sites More sharing options...
Lennox Member 2,586 Member For: 11y 8m 26d Gender: Male Location: Perth Posted 25/09/14 08:52 AM Share Posted 25/09/14 08:52 AM What's the tint 20/20? Looks good. Link to comment Share on other sites More sharing options...
"Captain Retard" Member 1,417 Member For: 10y 6m 19d Gender: Male Location: Shellharbour NSW Posted 25/09/14 08:52 AM Share Posted 25/09/14 08:52 AM Tyre profile??? Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now