Jump to content

What Did You Do To Your Car Today?


Henz

Recommended Posts

  • BANNED
  • Banned
  • Member For: 17y 8m 25d
  • Gender: Not Telling
  • Location: banned

Found a puddle of coolant under neath it, found the water pump I replaced a month or so ago is leaking again. (leaked straight after it was installed but that was due to not enough blue goop on the gasket)

Unfortunatelly I cant pin point the exact leak, looks like from behind the alternator bracket.

So I nipped all the water pump bolts up and topped up the coolant, degreased the bay and I'll check it tomorrow.

f*cking cars.

Sent from my GT-P7510 using Tapatalk 2

Here mate ??

298826_10150338507264029_564499028_.jpg

Here is a link to some more pic's ... did you grease the O'ring first?

http://s1114.photobu... on a Barra I6/

Edited by XR6menace
Link to comment
Share on other sites

  • Turboless
  • Donating Members
  • Member For: 13y 10m 26d
  • Gender: Male
  • Location: Geelong, Victoria

Those rims look awesome. Bit more low needed though imo!

Yeh my IP is also blocked it seems. So just using the phone. Was momentarily unblocked before..for 2mins lol :banghead:

Link to comment
Share on other sites

  • BANNED
  • Banned
  • Member For: 17y 8m 25d
  • Gender: Not Telling
  • Location: banned

Car will never be more lowered than it is now 10 kids and the car is always chockers with a steep driveway, std height is how it stays it is an everyday car..

Shoot the BOSS a pm mate a few of us are having this issue all good now though' just go to www.whatismyip.com and tell him what it is and it will be unblocked :)

Edited by XR6menace
Link to comment
Share on other sites

  • Member
  • Member For: 18y 11m 9d
  • Gender: Male
  • Location: Brisbane

Nar its all sweet at that pipe, learned that lesson years ago with my mates EB.

Definately pump to block it seems, could be leaking from the pulley shaft I guess - hard to tell.

Sent from my GT-P7510 using Tapatalk 2

Link to comment
Share on other sites

  • I am dissatisfied with my current employment situation
  • Donating Members
  • Member For: 18y 3m 25d
  • Gender: Male

Yeah bad. Also I trimmed the silicon hose too much gotta get new one off capa. It's holding for now.

Why trim it? Mine was fine

Link to comment
Share on other sites

  • Moar Powar Babeh
  • Lifetime Members
  • Member For: 19y 3m 30d
  • Gender: Male
  • Location: Perth

You took it out the hard way ralph.

Did not, took the seat of the base first, then pulled the base out so I could clean under it. Also not hard to remove torx becauserattlegun.

  • Like 1
Link to comment
Share on other sites

  • Carnage on the Garage Floor
  • Donating Members
  • Member For: 14y 8m 11d
  • Gender: Male
  • Location: Gold Coast

Yeah the phoon is his mates, he just looks after it.

and pretends its his, lol

Edited by Bomber
Link to comment
Share on other sites

  • Carnage on the Garage Floor
  • Donating Members
  • Member For: 14y 8m 11d
  • Gender: Male
  • Location: Gold Coast

Just jacked mine up and checked if I fitted the correct 02 sensor. All good :)

Edited by Bomber
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'