MY ROD GOT OUT Member 434 Member For: 14y 7m 27d Posted 27/06/12 09:42 AM Share Posted 27/06/12 09:42 AM Hey everyone, been trying to figure out a miss I have at idle and also when I rev to around 1500rpm in neutral the engine is missing slightly. Doesn't seem to hesitate at all when driving normally and boosts fine, just at idle and when revving in neutral, changed o2 sensor no change, already changed fuel filter as well. Thinking must be a coil on its way out? Also car struggles to kick over sometimes like its flooded. Bf manual only 60k on the clock. Your thoughts? Link to comment https://www.fordxr6turbo.com/forum/topic/80744-idle-and-rev-issue/ Share on other sites More sharing options...
Wenier Donating Members 1,736 Member For: 15y 3m 13d Gender: Male Location: Christchurch, New Zealand Posted 27/06/12 08:52 PM Share Posted 27/06/12 08:52 PM A coil will normally break down under load so if your not having any issues when boosting it it more than likely isnt your coils.On the front of the hard to kick over, hows your battery. Link to comment https://www.fordxr6turbo.com/forum/topic/80744-idle-and-rev-issue/#findComment-1260109 Share on other sites More sharing options...
MY ROD GOT OUT Member 434 Member For: 14y 7m 27d Posted 27/06/12 09:10 PM Author Share Posted 27/06/12 09:10 PM Battery is perfect, it turns over but splutters to start every now and then, would an inlet manifold leak cause the issue? Or was also thinking tps? Link to comment https://www.fordxr6turbo.com/forum/topic/80744-idle-and-rev-issue/#findComment-1260111 Share on other sites More sharing options...
Pete A Member 442 Member For: 16y 4m 28d Gender: Male Location: Castle Hill NSW Posted 28/06/12 02:10 AM Share Posted 28/06/12 02:10 AM Plugs? Link to comment https://www.fordxr6turbo.com/forum/topic/80744-idle-and-rev-issue/#findComment-1260176 Share on other sites More sharing options...
Shyfrd Turboless Donating Members 5,992 Member For: 14y 2m 4d Gender: Male Location: Geelong, Victoria Posted 28/06/12 02:17 AM Share Posted 28/06/12 02:17 AM Do the tps reset, hold accelerator pedal right down to the floor, and turn the keys like your trying to start it, it won't start but keep cranking it for about 10secs. Then obviously stop, take foot off and turn it on.Quick thing to do and see if it helps. Link to comment https://www.fordxr6turbo.com/forum/topic/80744-idle-and-rev-issue/#findComment-1260178 Share on other sites More sharing options...
Ralph Wiggum Moar Powar Babeh Lifetime Members 19,332 Member For: 19y 7m 8d Gender: Male Location: Perth Posted 28/06/12 02:20 AM Share Posted 28/06/12 02:20 AM ^ THAT does not reset the TPS. It resets the Cam phasers. The pcm carries out its on tps cycle test when you power up the car. 1 Link to comment https://www.fordxr6turbo.com/forum/topic/80744-idle-and-rev-issue/#findComment-1260180 Share on other sites More sharing options...
Shyfrd Turboless Donating Members 5,992 Member For: 14y 2m 4d Gender: Male Location: Geelong, Victoria Posted 28/06/12 03:08 AM Share Posted 28/06/12 03:08 AM Ah my bad :/ hahah forget that then! :D Link to comment https://www.fordxr6turbo.com/forum/topic/80744-idle-and-rev-issue/#findComment-1260203 Share on other sites More sharing options...
MY ROD GOT OUT Member 434 Member For: 14y 7m 27d Posted 28/06/12 04:21 AM Author Share Posted 28/06/12 04:21 AM Haha I think Ralph has to correct someone everytime there is a question bout a tps, maybe we need a sticky about how to reset CAM PHASERS not TPS!! But thanks anyway (tried that just incase and still no good), plugs are only bout 20,000k old so doubt it would be that. Link to comment https://www.fordxr6turbo.com/forum/topic/80744-idle-and-rev-issue/#findComment-1260229 Share on other sites More sharing options...
Ralph Wiggum Moar Powar Babeh Lifetime Members 19,332 Member For: 19y 7m 8d Gender: Male Location: Perth Posted 28/06/12 04:32 AM Share Posted 28/06/12 04:32 AM Can you pull any codes out of it? It could be a multitude of issues, sounds like and air leak at the manifold but without proper diagnosis everybodies taking pot shots in the dark Link to comment https://www.fordxr6turbo.com/forum/topic/80744-idle-and-rev-issue/#findComment-1260234 Share on other sites More sharing options...
MY ROD GOT OUT Member 434 Member For: 14y 7m 27d Posted 28/06/12 08:31 AM Author Share Posted 28/06/12 08:31 AM No codes.... Air leak at inlet manifold? Maybe my tb relocation is leaking? Have sprayed water all over that area and got nothing but mIght have to check it out. Just trying to save some coin by trying to find out myself Link to comment https://www.fordxr6turbo.com/forum/topic/80744-idle-and-rev-issue/#findComment-1260332 Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now