Jump to content

How Common For Fg To Throw Water Pump Pulley


old_mate

Recommended Posts

  • Member
  • Member For: 18y 8m 28d
  • Gender: Male
  • Location: Brisbane

Quick drive up to my folks place ended poorly tonight - temp warnings come up on the dash, temp guage well into the red, pop the bonnet to find water pump pulley missing. Belt somehow dropped into the remaining shaft but the whole pulley is gone.

Spoke to a relo who is Service Manager at a dealer in Central Queensland who has head of this four times now.

Warning signs about a week ago was a sqeaky belt which I fixed with belt conditioner (silicon spray basically) - obviously masking the real problem.

Gotta say, I was spun out to see a whole pulley missing. Sucks I am about 2 and a half months out of warranty too.

Anyone else been through/heard of this?

Edited by old_mate
Link to comment
Share on other sites

  • 3 weeks later...
  • Bronze Donating Members
  • Member For: 13y 1m 24d
  • Gender: Male
  • Location: Townsville

This happened to a mate of mine at work. He was a little more unlucky though. His resulted with the pully putting a good sized dent in the underside of his bonnet (you could see the big lump when he closed it) and then it got shot through his radiator. And his car wasnt even to 10000kms yet !!!

Link to comment
Share on other sites

  • 2 weeks later...
  • Member
  • Member For: 21y 7m 11d
  • Gender: Male

Today I was investigating a squeek, took the belt off to check the pulleys and the water pump pulley is phucked(FG turbo). One thing that comes to mind is that the belt tensioner is a pretty strong unit on the FG. Its puts way more pressure on that plastic pulley than say EF/EL tensioners. So we never really had these failures on those models, its just that this plastic pully has a hard time with the FG tensioner.

Anyway I am looking for an alluminium replacement as the plastic will just fail again. Duz anyone know who duz the ally ones. I have seen them.

Link to comment
Share on other sites

  • 4 weeks later...
  • Member
  • Member For: 16y 5m 22d
  • Gender: Male
  • Location: Brisvegas

Add another failure to the list. Found my pulley had come clean off the shaft and was sitting on at the bottom of the engine bay. Symptons were the same as old_mate plus a melted plastic/rubber smell from the engine bay over the past few days.

Car is stock with 75000km on it, and unfortunately 5months out of warranty :(

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'