Jump to content

Tips?


MiKa

Recommended Posts

  • Turboless
  • Donating Members
  • Member For: 13y 9m 1d
  • Gender: Male
  • Location: Geelong, Victoria

Alright cool cool, wasn't 100% sure myself anyway :)

Ah yeh totally forgot you mentioned that lol..and I should've remembered anyway, you can clearly see the 2 pipes in the standard muffler when behind a T. Easy way to tell if a turbo or not if it's debadged ;) haha

Link to comment
Share on other sites

  • Donating Members
  • Member For: 18y 3m 7d
  • Gender: Male
  • Location: Melbourne, VIC

Where about is hallam exhausts? I tried google but it came up with a few results?

Is it the one with the big hallam performance on the front of the shop, on David Lee rd?

Edited by MiKa
Link to comment
Share on other sites

  • Carnage on the Garage Floor
  • Donating Members
  • Member For: 14y 6m 17d
  • Gender: Male
  • Location: Gold Coast

Get twin 3" tips if you do. I've seen the quad xforce 2.5 and it's too small. I've got a driver side spare GT tip if you go that way

how is the manta system going? tried to send you a pm but all full mate, lol.

Link to comment
Share on other sites

  • Member
  • Member For: 20y 9m 15d
  • Gender: Male
  • Location: Melbourne

how is the manta system going? tried to send you a pm but all full mate, lol.

Sorry lol. No complaints here the drones gone thankfully and I've gotten used to the noise. It's a lot better than the single 3.5 x-force sound wise and it sounds good driving past from the outside. The noise in cabin is typical 6 cyl until boost but what can you do. Stock note is the best imo.

You have to polish the tips weekly too.

Link to comment
Share on other sites

  • Donating Members
  • Member For: 18y 3m 7d
  • Gender: Male
  • Location: Melbourne, VIC

Well went to Hallam Performance today and I understand what Dre said about closing your eyes lol.. the place is a mess and friggin dirty.. Barney seems like a good bloke though and they didn't have time to fit up the bit today so I've booked it in for thursday morning.

This morning I cut out the hole in the rear bar needed for the exhaust. Piece of piss, just measured it up got the hack saw blade and went nuts, then smoothed it up.

Now to get on the phone to best mufflers and get those tips.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'