Jump to content

Coolant Flush W/o Radiator


John Harvey

Recommended Posts

  • Member
  • Member For: 14y 11m 15d
  • Gender: Male
  • Location: two wells....the bush

Hey all,

Just wondering if I would run into any trouble flushing out the engine and hoses without a radiator. Pulled the old crappy radiator out and waiting for the arrival of my new radiator. Just wanna flush all the crap out before putting the new one in.

Just a garden hose in either side for a while should do a good enough job and then a full flsuh once the new radiator is in?

Thansk guys.

Link to comment
Share on other sites

  • Donating Members
  • Member For: 16y 2d
  • Gender: Male
  • Location: SE Melbourne

1. Unscrew coolant bottle cap

2. Undo butterfly screw bottom right (front on) of radiator and drain the coolant.

3. Place hose in coolant bottle and fill until water is coming out of bottom of radiator.

4. With the hose running, start the car and turn the heater on full.

5. Run it like this for around 3-5 mins.

6. Turn car and hose off and wait for water to drain.

7. Fill with pre-mixed coolant

8. Start car and top up as necessary.

You wont get all the water out unless you use a crap load of coolant but the above method is fine for the next 30-50 thou ks..

Edited by Paulie2256
Link to comment
Share on other sites

  • Donating Members
  • Member For: 16y 2d
  • Gender: Male
  • Location: SE Melbourne

You can get coolant in concentrated form which you have to mix with water. If you get it wrong it will corrode your cooling system. You can get pre mixed coolant in 5L bottles which you just pour in. You will need 2 bottles.

Link to comment
Share on other sites

  • I am dissatisfied with my current employment situation
  • Donating Members
  • Member For: 18y 1m 27d
  • Gender: Male

Ahh 2 birds with one stone as I was gonna say I though you filled it up with water the topped the overflow bottle with coolant

Link to comment
Share on other sites

  • Donating Members
  • Member For: 14y 2m 27d
  • Gender: Male

do you have to remove the bottom air deflector? I was thinking the coolant might drip into it?

also if you run the car for 3-5mins,switch off then drain and fill with cold hose water cant this cause issues?

Link to comment
Share on other sites

  • Donating Members
  • Member For: 16y 2d
  • Gender: Male
  • Location: SE Melbourne

I didn't say anything about re-filling the car with cold water after running it but answer is still no. With the car running and the water constantly draining/filling and not recirculating the car probably won't have a chance to heat up too much anyway. You just need enough engine temp for the thermostat to open so 5 mins should be enough.

Also, coolant won't hurt your car. Just hose it down when you finished. Its water soluble.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'