Jump to content

Compression Test On Bf


shaneo_1

Recommended Posts

  • Member
  • Member For: 17y 8m 19d

Was going to do a comp test on my ute this weekend as I suspect I have a blown head gasket , getting pressure in the radiator,

just wondering if its like older cars, disconnect coil coils in thus case, stop the fuel? Maybe by removing fuse for fuel pump.

is this how u do it? I have been told to watch as ecu may play up if coil packs art connected.

Can anyone explain the steps to comp test on ba bf

thanks

Link to comment
Share on other sites

  • Donating Members
  • Member For: 21y 11m
  • Gender: Male
  • Location: Perth, WA

Just remove coil packs and spark plugs, and if you like, fuse for fuel pump (though not strictly necessary) and crank engine to read compression. You will need a good compression tester which will reach the plug threads, as they are quite deep in the head.

I have never had any problems cranking without the coil packs.

Link to comment
Share on other sites

  • Donating Members
  • Member For: 14y 10m 6d
  • Gender: Male
  • Location: Christchurch, New Zealand

While cranking just put your foot flat down on the throttle as it stops the injector cycle so you can crank without getting any fuel in the cylinders.

  • Like 1
Link to comment
Share on other sites

  • Member
  • Member For: 14y 4m 4d
  • Gender: Not Telling

Its not unusaul for the head gaskets to go in the 6th cylinder, and I suspect that water is leaking into the piston, thus the noise. Only one good thing about this is when you pull the head off it will be sparkling clean, Cheers

Edited by Impellor
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'