Jump to content

Engine Builder Melbourne


Dillz

Recommended Posts

  • Three pedals are better then two..
  • Donating Members
  • Member For: 17y 5m 11d
  • Gender: Male
  • Location: Melbourne

Just wondering if anyone can recommend a good engine builder in Melbourne? Preferably expericed with the I6.

Cheers

Link to comment
Share on other sites

  • Here since the start...
  • Lifetime Members
  • Member For: 21y 6m 10d
  • Gender: Male
  • Location: Victoria

Nizpro.

I know someone will say they're expensive, but there's no point cutting corners with an engine build. Doubt you'll find anyone with as much experience as them in building these engines.

  • Like 1
Link to comment
Share on other sites

  • Three pedals are better then two..
  • Donating Members
  • Member For: 17y 5m 11d
  • Gender: Male
  • Location: Melbourne

Nah my cars fine, can pick it up today.

I'd prefer to stay away from Nizpro but can't hurt to have a chat with them.

Link to comment
Share on other sites

  • Three pedals are better then two..
  • Donating Members
  • Member For: 17y 5m 11d
  • Gender: Male
  • Location: Melbourne

Unless you walk in there with a blank cheque they usually don't bother. That was a while back though, might be be different though now.

That and I would probably be obliged to get it tuned there too.

Link to comment
Share on other sites

  • Donating Members
  • Member For: 18y 2m 15d
  • Gender: Male
  • Location: Melbourne, VIC

Atomic seem to be the only place worth going, judging by others on the site... Seem to have the most runs on the board, the fact that they're in NSW is a factor though..

The place I'd go to if I were in that position..

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'