Jump to content

Recommended Posts

  • Replies 44
  • Created
  • Last Reply

Top Posters In This Topic

  • I see a red door and I want to paint it black
  • Donating Members
  • Member For: 15y 6m 17d
  • Gender: Male
  • Location: Far north queensland

bloody good gains in the mid range looking at that chart.

  • Donating Members
  • Member For: 18y 8m 21d
  • Gender: Male
  • Location: Melbourne, VIC

Im on ~250rwkw and run about 13-14psi.. Std exhaust doesn't help, prob make ~300 on the same boost with one..

  • Member
  • Member For: 16y 9m 9d
  • Gender: Male
  • Location: Geelong

The Lurker

Correct 8Psi will see 260-270rwkw but as you can see the additional low dowm RPM boost has increased power and torque in a hugh way in the lower RPM range where the power can be used on the road. This tune Hits 14Psi and holds 10-11Psi. The factory actuator is doing good job to hold 10Psi where most I have seen drop off to 7-8Psi.

Edited by BPRacing
  • Member
  • Member For: 16y 9m 9d
  • Gender: Male
  • Location: Geelong
  On 12/10/2011 at 7:07 AM, Slash said:

Intake Temp is quite a bit higher than Ambient Temp...

High Intake temps as a result of the continuouse dyno runs will contribute to a lower dyno figure in the final result.

Run it up cold may allow the car to produce additional 10rwkw

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.



×
  • Create New...
'