Jump to content

Got The Ba Custom Tuned, Heres The Dyno Sheet


earle13

Recommended Posts

  • A much better forum
  • Silver Donating Members
  • Member For: 16y 7m
  • Gender: Male
  • Location: Victoria

My car is closer to 300 with 10-11psi...

14-15 psi for that power is farked!!!

With some more fuel (a bigger pump) we would have easily seen 300 rwkw on 11psi through an auto... Over 300 it was running a little lean so we pulled it back a bit...

Edited by Worm
Link to comment
Share on other sites

  • Replies 44
  • Created
  • Last Reply

Top Posters In This Topic

  • Donating Members
  • Member For: 17y 7m 29d
  • Gender: Male
  • Location: south east suburbs

High Intake temps as a result of the continuouse dyno runs will contribute to a lower dyno figure in the final result.

Run it up cold may allow the car to produce additional 10rwkw

Higher intake temps can result in detonation, that's why its always a good idea not to skimp on a decent intercooler.

Link to comment
Share on other sites

  • Member
  • Member For: 13y 8m 13d

so fuel pump doesnt really do much for me haha oh well did it myself so all good, id love another cooler but im not planning on ever running it down the strip and assumed the wog would be fine for a squirt here and there on the street?

Link to comment
Share on other sites

  • Donating Members
  • Member For: 14y 4m 12d
  • Gender: Male
  • Location: Mt Gambier, SA

I had a similar result with a flash tune recently. Removed the Unichip, and put in a flash, and picked up over 60rwkw in the low to mid range, and only 20rwkw at the top end. End result was 283rwkw.

It hauls arse now that's for sure :sungum:

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.



×
  • Create New...
'