Jump to content

Sa Members


animalxr6t

Recommended Posts

  • Turbo Noob
  • Donating Members
  • Member For: 12y 3m 20d
  • Gender: Male
  • Location: Adelaide

Spotted a black fg pursuit, white r-spec and nitro fg xr6t at the bay (together). Any one from this forum?

Link to comment
Share on other sites

  • Member
  • Member For: 12y 7m 26d
  • Gender: Male

hey guys,

you all know you shiitee better then any one and was wondering if you could give me a bit of advice..... had a bit of a miss happening at about 42-4500rpm so I put new plugs and coils in.... Now at three quarter throttle it is fine, but at WOT when it gets to 4500 it is like it dies and then goes pop, pop, pop, then continues on after that. I am pretty new to the T's so any advice would be great.

Cheers

Link to comment
Share on other sites

  • ...JD TUNING ADELAIDE...
  • Gold Donating Members
  • Member For: 16y 7m 13d
  • Gender: Male
  • Location: Adelaide

Close that plug gap down

What is it

It should be aprox 8mm

How much boost is it running ?

Who tuned it ?

Link to comment
Share on other sites

  • Member
  • Member For: 12y 7m 26d
  • Gender: Male

ok, not sure on plug gap, got the local mechanic to supply and fit, cause I am use less.... will find out and let you know

boost, can only go on what I see on the gauge, and peaks at 12psi

have only had the car since dec last year, but was tuned by morpowa in 06 I think.

nah, full tank and still the same prob

Link to comment
Share on other sites

  • GONE FULL WIZARD
  • Donating Members
  • Member For: 16y 7d
  • Gender: Male
  • Location: 720 East Kensington Road

Sounds like what mine did on the dyno last year, mine would hit 5000rpm sort of stop dead and then take off again, never figured out what it was though, I drove it on the dyno and don't really seem to have the problem on the street, that or I'm not going hard enough.

Link to comment
Share on other sites

  • ...JD TUNING ADELAIDE...
  • Gold Donating Members
  • Member For: 16y 7m 13d
  • Gender: Male
  • Location: Adelaide

Bet the mech just wacked in the plugs at 1.1mm ( out the box gap )

Gap em down to 0.8mm and ull be right

Post back if it fixes it bloke

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'