Jump to content

Bf Injector Installation Possible O-Ring Issue


Pube

Recommended Posts

  • Member
  • Member For: 17y 7m 11d
  • Gender: Male
  • Location: Sydney, NSW

I just finished swapping some injectors. The new ones are standard, just cleaned. Installation went ok, just a bit of a pain with all the LPG gear in the way. No leaks and she runs fine.

However, when I was cleaning up I noticed that one of the old injetors was missing an o-ring that would have been on the fuel rail side. Without pulling everything apart, is it possible that the old o-ring is still stuck in the fuel rail along with the new injector? Is it even possible??? Or is it more likely that I have dropped an o-ring in the engine bay somewhere?

There are no leaks, engine runs fine but its just at the back of my head that im missing the o-ring and its still in the fuel rail. I had a look around the side of the engine when everything was back together and I couldnt spot the missing o-ring.

Link to comment
Share on other sites

  • 1 month later...
  • Donating Members
  • Member For: 19y 11m 14d
  • Gender: Male
  • Location: Brisbane

were the injectors easy to install? thinking about installing new 60's myself before going for a tune. is there anything I should watch out for to save some $$, apart from o-rings?

cheers

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'